Philips 14PV210 manual Installing Your TV-VIDEO Combi, Initial installation Allocating a decoder

2.INSTALLING YOUR TV-VIDEO COMBI

Initial installation Allocating a decoder

aOpen up the battery compartment of your remote control and place the batteries in it as shown in the picture.

bClose the battery compartment.

cIf you have connected the aerial to the TV-VIDEO Combi, press the OK button.

’Automatic TV channel search’ starts. This picture will appear on the screen:

Searching...

CHANNELS FOUND:

//////,,,,,,,,,,,,,,,,,,,,,

Wait until all TV channels have been found. This can take several minutes.

If you have connected a decoder, you must install it as described in the next section.

If you have connected a satellite receiver, please read the section ’satellite receiver’.

Some TV stations will send coded TV channels, that you can only watch when you use a decoder. You can connect such a decoder (descrambler) to your TV-VIDEO Combi. With the following function, the connected decoder will automatically be activated for the TV programme you want to watch.

aChoose the TV channel on which you wish to use the decoder with the P pAB button on the TV-VIDEO

Combi or the number buttons 0-9on the remote control.

bPress the MENU button on the remote control. The main menu will appear.

c Select the line ’Installation’ with the P rB or

AP q buton and confirm with the SqC button.

d Select the line ’Manual store’ with the P rB or

	AP q	button and confirm with the		SqC			button.
e Select the line ’Decoder’ with the						or
					P rB
		button.
	AP q
	MANUAL STORE
	Channel/Frequency		FREQU.
	Search		125
	Fine tuning (,,,,,,n=,,,,,,$
	Name edit		xxx
	Programme number		01
	Decoder		OFF

ã Exit:

« press MENU

fSelect function ’ON’ with the DSr or SqC button. When you select ’OFF’, the function will be switched off.

gConfirm with the OK button.

hTo end, press the MENU button.

Your decoder has now been allocated to this TV channel.

i Press the MENU button again.

5