Philips CC19C1MG, CC13C1MG Recording, Read and follow the steps below to record a TV program, Hrs

Page 29

Read and follow the steps below to record a TV program.

1

Place a tape with its record tab intact (see page five) in the TV/VCR. The power will come on. Or, if the tape is already in the TV/VCR, press the POWER button to turn on the TV/VCR, if necessary.

2

Press the SPEED button until the desired tape speed appears on the TV/VCR screen. See tape speed details below.

3

Use the CH(annel) o/p buttons or the Number buttons to select the channel you want to record. You can not change channels during recording.

4

Press the REC(ord)/OTR button once to start recording.

The Record light will glow.

●If there is not a tape in the TV/VCR, NO CASSETTE flashes on the screen briefly.

●If the tape does not have a record tab, PROTECTED CASSETTE CANNOT RECORD flashes on the screen briefly. The TV/VCR will eject the tape. Insert another tape.

5

To pause the recording (for example, during commercials), press the PAUSE/STILL button. The Record light will flash. To resume recording, press the PAUSE/STILL button again or the REC(ord)/OTR button. The Record light will glow.

6

To stop recording, press the STOP/▼ button.

Tape Speeds

This chart shows the recording/playback time for three types of video cassettes (T160, T120, and T60). There are three playback speeds: SP, LP, and SLP. A tape will play only in the speed in which it was recorded. When recording, you can change the tape speed using the SPEED button. You cannot record in LP speed.

The slower the speed, the more programming you can fit on the tape. SLP is the slowest speed.

 

Cassette type / Playback Time

Tape Speed

T160

T120

T60

SP(Standard Play)

2 hrs.

2

hrs.

1 hr.

 

40 mins.

 

 

 

 

LP(Long Play)

5 hrs.

4

hrs.

2 hrs.

(playback only)

20 mins.

 

 

 

SLP(Super Long Play)

8 hrs.

6

hrs.

3 hrs.

 

 

 

 

 

 

Recording 29

1

EJECT

POWER

MENU STATUS/EXIT CLEAR

1 2 3

4 5 6

 

7

8

9

4

 

SLEEP/

 

ALT.CH

 

WAKE UP

0

3

 

 

REC

PLAY

PAUSE

/OTR

/STILL

REW

 

F.FWD

5

STOP

CH.

MUTE

VOL.

6

 

SPEED

 

2

TRACKING

MEMORY

 

Helpful Hints

•You cannot record one channel while watching another.

•Recording options are on pages 30-36.

•You cannot record if DEFEAT RECORDING is ON. (REC DEFEATED will flash on the screen.) Details are on page 36.

•If you pause a recording for more than five minutes, the TV/VCR will switch to Stop mode automatically to protect the video cassette tape from damage.

•You can change the tape speed with the SPEED button while a recording is in progress, but some distortion may appear on the tape.

Page 28 Page 30
Image 29
Page 28 Page 30
Contents
Tvcr For Customer Use Warranty VerificationSafety Precautions FeaturesIntroduction Declaration of ConformityTable of Contents Using the Remote Control Battery SafetyTV/VCR Maintenance Replace the battery compartment lidHooking Up the TV/VCR Hook up your TV/VCR using one of the connections shownRF coaxial cable Not supplied Rod AntennaBent pin Hooking Up the TV/VCR cont’dCrooked Pin Straight Pin Cable PlugPress the Menu button. The screen shown below will appear Turning On the TV/VCRSelect Language English Español Select KL To END Press Exit Language SelectionPress the Menu button Wait for the TV/VCR to set up channels Automatic Channel SetupPress the PLAY/o button or the STOP/p button to select Adding/Deleting ChannelsRepeat steps 3-4 to add or delete other channels Programming of the channel you added or deleted will appearCable Box users must set the clock manually Setting the ClockManual Clock Setting SET Manual Clock Time SET Manual Clock Time Date To END Press ExitMonth To Correct Press Clear To END Press Exit Date Sunday To Correct Press Clear To END Press ExitPRIM. Setup Press B Setting the Clock cont’dVCR Program VCR Setup Caption Reminder Brightness Automatic PBS Channel SelectionWait for the TV/VCR to find the time NOW Searching flashes on the TV/VCR screenSET Auto Clock Time Date NOW Searching To END Press Exit SET Auto Clock TimeManual PBS Channel Selection Use the Number buttons to select your PBS station PRIM. Setup Press B VCR Program VCR Setup PRIM. SETUP. Then, press the F.FWD/B buttonDaylight-Savings Time Press the PLAY/ button or the STOP/ button to selectVolume BAR SET Clock Select KL Choose B To END Press Exit Primary SetupTime Zone Press the Menu button, then press the STATUS/EXIT buttonFront Panel Rear Panel AC Power CordANTenna Jack Connect your antenna or cable here. Details are on page sixRemote Control Buttons STATUS/EXIT Button Menu ButtonREWind/ Button STOP/ ButtonWhen you finish, press the STATUS/EXIT button Adjusting the Picture Controls Tint KK Sharpness TV Reset Adjusting the Picture Controls cont’d Decrease Increase Decreased brightnessIf you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFFOFF ReminderInsert a tape in the TV/VCR PlayingFollow the steps below to play a tape Read and follow the steps below to record a TV program RecordingTo stop recording, press the STOP/ button Tape Speeds HrsOne-Touch Recording Length Press OTR Cancel Press ClearTape is in the TV/VCR. The record tab must be intact Press the STOP/EJECT but- ton on the TV/VCR to stop the OTRRerecording Tape Duplication TV/VCR is now in Line Input modeSelect Program Number To END Press Exit Timer RecordingDaily Time OFF To Correct Press Clear To END Press Exit ONE Time Program Channel Time onTimer Recording cont’d With the TV/VCR on, press the Menu button Timer recording information for the program in the lowestProgram REVIEW, then press the F.FWD/B button Gram Review and press the F.FWD/B buttonDefeat Recording VCR Setup ONE Time PlayFollow the steps below to prevent accidental recording REC DefeatedVCR Setup ONE Time Play Repeat Play on VCR SETUP, then press the F.FWD/B buttonRepeat Play TV programming will appear while the tape is rewindingInsert a tape in the TV/VCR Press the Menu button VCR Setup ONE Time Play Repeat Play A-BB Repeat Play Repeat Repeat Play cont’dStop Real-Time Counter MemoryAppear on the screen Viewing a Still Picture Forward and Reverse Searching SP/LP/SLPSuper High Speed Searching LP/SLP Smartlock menu will appear SmartLockTo block ratings, follow the steps below Example Specific Sub-ratings SmartLock cont’dRatings are defined on After you enter the code, the Smartlock menu will appear To change the access code, follow these stepsTV-Y7 TV-G Blocked RatingsBlue Background VCR Program VCR Setup Caption ReminderPress the SLEEP/WAKE UP button Sleep TimerTimer during a recording Timer Sleep Wake UP Wake Up TimerTimer Sleep Wake UP TV on ON-TIME VCR Program VCR Setup Caption Volume BarClosed Caption To Adjust Press / B CaptionExample Menu ScreenHalf-screen text Closed Caption cont’dStandard Closed Captions Automatic Operation Features Glossary Helpful Hints Helpful Hints cont’d Specifications Renewed Index Page Supplied Accessories
Top Page Image Contents