Philips CCA132AT owner manual Specifications, Glossary

Page 51

Specifications

General

CRT: 13-inch in line gun

Television system: NTSC-M

Closed caption system: Section 15.119, FCC (Federal Communications Commission) Standard

Video Heads: Two heads

Tape width: 1/2 inch (12.65 mm) Tape speed

SP: 33.35 mm/sec.

LP: 16.67 mm/sec.

SLP: 11.12 mm/sec.

Operating Temperature: 41˚F (5˚C) to 104˚F (40˚C)

Relative Humidity: 10% to 75%

Power requirement: AC 120V, 60Hz

Power consumption: 65W

Sound output: 1W Dimensions:

15-13/16" (H) x 15-3/16" (W) x 14-13/16" (D) 402mm x 386mm x 376mm

Weight: 24.3 lbs (11.0 kg)

Tuner Broadcast Channels

VHF 2-13, UHF 14-69

Cable TV Channels

Midband: A – 1

Superband: J – W

Hyperband: A-5 – A-1

Special Channel: 5A

Ultraband: 37 – 94, 100 – 125

Terminals

Antenna IN: VHF/UHF 75 ohms unbalanced

Video In: RCA connector

Audio In: RCA connector

Earphone: 3.5 mm CES

Electrical Specifications

Video input level: 0.5~2.0Vp-p

Audio input level: -10dBv

Video S/N ratio

SP: More than 42dBµ

Audio S/N ratio

SP: More than 38dB

Designs and specifications are subject to change without notice and without our legal obligation.

Specifications / Glossary 51

Glossary

AUDIO Jack: jack located on the front of the TV/VCR which is used to record audio from anoth- er source.

Automatic Channel Setup: process in which the TV/VCR scans all available channels and places the ones you receive in its memory. Then, when you push the CHANNEL o/p buttons, you only scan through channels you receive.

Bands: settings that allow you to tune channels.

•Antenna – VHF (very high frequency; channels 2-13) and UHF (ultra high frequency; channels 14-69).

•Cable – all standard channels can be received without a Cable Box.

Brightness: adjusting increases or decreases the brightness of the color on-screen.

Color: adjusting pales or brightens the TV/VCR color.

Dubbing: copying a tape using a VCR.

HQ: high quality; a feature in the TV/VCR circuitry which provides enhanced picture detail.

Line Input: The channel to which you set your TV/VCR during dubbing. The line input channel is always channel 00 (A/V IN).

Mode: a TV/VCR operation.

OTR: One-Touch Recording; a timed recording that starts immediately and records for 30 minutes to eight hours, whichever you specify.

Picture: adjusting increases or decreases the con- trast of the picture on-screen.

Sharpness: adjusting softens or clarifies the picture on-screen.

Tape Speeds: how fast the tape travels during playback or recording.

•SP (standard play) – fastest tape speed (record- ing time for a T120 tape is approximately two hours); best picture quality.

•LP (long play) – average tape speed; playback only.

•SLP (super long play) – slowest tape speed (recording time for a T120 tape is approximately six hours).

Tint: adjusting changes the tints of the picture on the TV/VCR from purple to green.

VIDEO Jack: jack located on the front of the TV/VCR which is used to record video from anoth- er source.

Page 50 Page 52
Image 51
Page 50 Page 52
Contents CCA132AT For Customer Use Dear Philips Magnavox product ownerPhilips Consumer Electronics Company recommends that FeaturesSafety Precautions IntroductionTable of Contents Erasure Prevention Putting Batteries in the Remote ControlUsing the Remote Control TV/VCR MaintenanceHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Crooked Pin Straight Pin Hooking Up the TV/VCR cont’dYou cannot set up channels if you are using a Cable Box Turning On the TV/VCRTons to select another channel Press the STATUS/EXIT button Press the Menu buttonAutomatic Channel Setup Adding/Deleting Channels Press the PLAY/ o button or the STOP/ p button to selectPress the STATUS/EXIT button once or twice Setting the Clock Manual Clock SettingCable Box users must set the clock manually Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’dWait for the TV/VCR to find the time Manual PBS Channel Selection Select SET PBS CH. MANUAL. Then, press the F.FWD/B Press the PLAY/ button or the STOP/ button toDaylight-Savings Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons Menu Button STOP/ ButtonREWind/ Button STATUS/EXIT ButtonAdjusting the Picture Controls Softer Adjusting the Picture Controls cont’dDecrease Increase More brilliantIf you select Status OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status ON, then select Counter only onReminder Press the PLAY/ button or the STOP/ button to selectPlaying Distortion may appear on the tape RecordingGiven below Recording options are on pagesOne-Touch Recording Rerecording Tape Duplication Different brands of equipment may operate differentlyAudio and video cables are not included Daily Timer RecordingRect information Timer Recording cont’dTimer Recording cont’d With the TV/VCR on, press the Menu button Checking or Clearing Timer RecordingsDefeat Recording Repeat Play Insert a tape in the TV/VCR Press the Menu button B Repeat PlayPress the STATUS/EXIT button to remove the display. a Repeat Play cont’dPress the STATUS/EXIT button. The real-time counter will Real-Time Counter MemoryViewing a Still Picture Playback OptionsForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPSmartLock Example Specific Ratings SmartLock cont’dTo change the access code, follow these steps Ground Blue BackgroundIf the power fails, you might lose Sleep timer setting Setting the Sleep TimerVolume Bar Screen Closed CaptionExample MenuClosed Caption cont’d May be delayed for a few secondsAutomatic Operation Features Glossary SpecificationsHelpful Hints Helpful Hints cont’d TV/VCR Combination Limited WarrantyIndex Channel Above Adding Deleting Reviewing Setup ButtonsSupplied Accessories
Top Page Image Contents