8 Turning On the TV/VCR
Before you turn on the TV/VCR, make sure there are batteries in the remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the TV/VCR for the first time.
1
Press the POWER button. The TV/VCR will come on and the screen shown below will appear.
SELECT LANGUAGE
> ENGLISH | ON |
ESPAÑOL
SELECT KL OR
PRESS MENU TO CONTINUE
2
Press the PLAY/K button or the STOP/L button to select
English or Spanish
3
Press the MENU button. The screen shown below will appear.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
TO END PRESS EXIT
4
Press the F.FWD/B button to begin automatic channel setup. The TV/VCR will memorize all available channels. When channels are set, CHANNELS ARE SET will appear
(If you try to set up channels when there is no antenna or cable connected to the TV/VCR, programming will appear to take place, but eventually a NO TV SIGNALS ... message will appear on- screen. Connect an antenna or cable to the ANT(enna) jack on the TV/VCR, then press the F.FWD/B button again. You may need to follow the steps on page 10 instead.)
5
Use the CH(annel) m/n button or the Number buttons on the remote control to select a TV/VCR channel. Use the VOL(ume) m/nbutton to adjust the sound.
1 | POWER |
|
|
| SLEEP |
|
2 |
| PLAY |
|
| 4 | |
REW | STOP |
| F.FWD | |||
3 | MENU | STATUS/EXIT | CLEAR |
| ||
1 | 2 |
| 3 |
|
| |
| 4 | 5 |
| 6 | CH. |
|
5 |
|
|
| |||
7 | 8 |
| 9 |
|
| |
| 0 | ALT. CH | VOL. |
| ||
|
|
| ||||
SPEED MEMORY | PAUSE/STILL |
| ||||
| REC/OTR | TRACKING |
| MUTE |
|
Helpful Hints
•If you do not see any
•To skip step 2, press the MENU button. All
•You cannot set up channels if you are using a Cable Box.
•Line Input mode will always be stored in the TV/VCR’s memory as channel 00. When you select chan- nel 00, A/V IN will appear on- screen briefly. Press the CH(annel) m/n button or the Number but-