Philips CCA132AT owner manual Timer Recording cont’d, Rect information

Page 33

Timer Recording (cont’d) 33

4

Use the Number buttons (1-8) to select a position in which to store the timer recording. Flashing numbers indi- cate an open position (one in which a timer recording has not been stored yet).

NOTE: If you select a number that already has been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on-screen for a few seconds. Then information about the program in that position will appear on-screen. If this happens, press the STATUS/EXIT button. Then use the Number buttons to select another position.

5

Use the Number buttons to enter the channel of the TV program you want to record.

●If you are recording from line input, press 0, 0. A/V IN will appear on-screen.

●If you are recording using a Cable Box, enter the Cable Box output channel (03 or 04). Be sure to select the channel of the TV program at the Cable Box and leave the Cable Box on for the timer recording.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL – – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

6

Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

7

Follow the instructions in step 6 to set the recording’s stop time. (AM or PM will be set automatically.)

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	09:30 PM
TIME OFF	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Instructions continue on page 34.

4-7

POWERSLEEP

	PLAY
REW		F.FWD
	STOP
MENU	STATUS/EXIT	CLEAR

1	2	3
4	5	6	CH.
4	5	6
7	8	9
	0	ALT. CH	VOL.
	0	ALT. CH
SPEED	MEMORY	PAUSE/STILL
REC/OTR	TRACKING		MUTE

Helpful Hints

•If the numbers entered do not match the TV/VCR’s calendar, the entry will be rejected and a question mark will appear on-screen.

•To make corrections while you are programming a timer recording, press the CLEAR button until the cursor is flashing on the item you want to change. Then enter the cor-

rect information.

Image 33

Contents CCA132AT For Customer Use Dear Philips Magnavox product ownerSafety Precautions FeaturesIntroduction Philips Consumer Electronics Company recommends thatTable of Contents Using the Remote Control Putting Batteries in the Remote ControlTV/VCR Maintenance Erasure PreventionHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Crooked Pin Straight Pin Hooking Up the TV/VCR cont’dYou cannot set up channels if you are using a Cable Box Turning On the TV/VCRTons to select another channel Press the STATUS/EXIT button Press the Menu buttonAutomatic Channel Setup Adding/Deleting Channels Press the PLAY/ o button or the STOP/ p button to selectPress the STATUS/EXIT button once or twice Setting the Clock Manual Clock SettingCable Box users must set the clock manually Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’dWait for the TV/VCR to find the time Manual PBS Channel Selection Select SET PBS CH. MANUAL. Then, press the F.FWD/B Press the PLAY/ button or the STOP/ button toDaylight-Savings Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons REWind/ Button STOP/ ButtonSTATUS/EXIT Button Menu ButtonAdjusting the Picture Controls Decrease Increase Adjusting the Picture Controls cont’dMore brilliant SofterIf you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFFReminder Press the PLAY/ button or the STOP/ button to selectPlaying Given below RecordingRecording options are on pages Distortion may appear on the tapeOne-Touch Recording Rerecording Tape Duplication Different brands of equipment may operate differentlyAudio and video cables are not included Daily Timer RecordingRect information Timer Recording cont’dTimer Recording cont’d With the TV/VCR on, press the Menu button Checking or Clearing Timer RecordingsDefeat Recording Repeat Play Insert a tape in the TV/VCR Press the Menu button B Repeat PlayPress the STATUS/EXIT button to remove the display. a Repeat Play cont’dPress the STATUS/EXIT button. The real-time counter will Real-Time Counter MemoryForward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still PictureSmartLock Example Specific Ratings SmartLock cont’dTo change the access code, follow these steps Ground Blue BackgroundIf the power fails, you might lose Sleep timer setting Setting the Sleep TimerVolume Bar Example Closed CaptionMenu ScreenClosed Caption cont’d May be delayed for a few secondsAutomatic Operation Features Glossary SpecificationsHelpful Hints Helpful Hints cont’d TV/VCR Combination Limited WarrantyIndex Channel Above Adding Deleting Reviewing Setup ButtonsSupplied Accessories