Philips CCB 092AT owner manual Hooking Up the TV/VCR cont’d, Mobile Connections, Cigarette Lighter

Page 8

8 Hooking Up the TV/VCR (cont’d)

Mobile Connections

Usually, the supplied indoor rod antenna provides adequate reception. But when you want to watch TV outdoors or in a vehicle, use a mobile antenna (not supplied) or an indoor dipole antenna (not supplied) and a car battery cord (supplied) to get good reception.

1

Connect an antenna to the ANT(enna) jack. Refer to the instructions with your mobile antenna to make a connection simi- lar to this one.

Mobile Antenna

(not supplied)

ANT.

2

Make sure your vehicle has a 13.2-volt, negative ground electrical system. Connect one end of the car battery cord to the DC 13.2V jack on the back of the TV/VCR. Then connect the other end of the car battery cord to the cigarette lighter in your vehicle.

Fuse Replacement

(Car Battery Cord)

If the TV/VCR does not have power when connected properly in your vehicle, you may need to replace the fuse in the car battery cord.

Use only a 5-amp, 250-volt, fast blow fuse, which is available at an electronics retailer.

1

To remove the old fuse, unscrew the red cap from the end of the cord. Place your fingers on the grooved part of the cap and turn the cap counter-clockwise.

2

When the cap is removed, the red cap and the silver tip will be loose. The fuse will be loose inside the end of the cord.

3

Remove the old fuse and insert a new fuse.

4

Replace the red cap and the silver tip. The fuse will tighten into place as you screw on the cap, turning the cap clockwise. (The end of the fuse will fit into the silver tip, which is in the center of the red cap when tightened.)

DC 13.2V

AC 120V

car battery cord

(supplied)

To

Cigarette

Lighter

Helpful Hints

Do not watch TV while driving.

Use only the supplied car battery cord. Using another cord could dam- age the TV/VCR.

Make sure the cigarette lighter jack is free of ashes and other debris.

Make sure you push the car battery cord’s plug completely into the ciga- rette lighter.

Always unplug the car battery cord from the cigarette lighter before you unplug it from the TV/VCR.

You must disconnect the car battery cord from the TV/VCR before you can use standard electrical (AC) power.

If you use the TV/VCR with the vehi- cle’s engine off, recharge the vehicle’s battery every four hours. Unplug the car battery cord from the cigarette lighter when you finish using the TV/VCR.

When you use the TV/VCR with a car battery cord, noise may appear on the TV/VCR screen.

Do not use this TV/VCR in high tem- perature conditions.

Image 8
Contents CCB092AT Dear Philips product owner For Customer UseFeatures Safety PrecautionsIntroduction Declaration of ConformityTable of Contents Putting Batteries in the Remote Control Using the Remote ControlTV/VCR Maintenance Recording PreventionHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRStraight Pin Rod Antenna suppliedCrooked Pin Cigarette Lighter Hooking Up the TV/VCR cont’dMobile Connections You cannot set up channels if you are using a Cable Box Turning On the TV/VCRLanguage Selection Press the Menu buttonAutomatic Channel Setup Adding/Deleting Channels Press the PLAY/ o button or the STOP/ p button to selectCable Box users must set the clock manually Setting the ClockManual Clock Setting Setting the Clock cont’d Setting the Clock cont’d Automatic PBS Channel SelectionWait for the TV/VCR to find the time Manual PBS Channel Selection Press the PLAY/ button or the STOP/ button to Select SET PBS CH. MANUAL. Then, press the F.FWD/BButton Use the Number buttons to select your PBS stationDaylight-Savings Time Time Zone Front Panel Rear Panel ANTenna JackDC 13.2V Jack AC 120V JackRemote Control Buttons Remote Control Buttons cont’d Adjusting the Picture Controls More brilliant Adjusting the Picture Controls cont’dDecrease Increase If you select Status OFF If you select Status ON, then select Counter only OFFIf you select Status ON, then select Counter only on Reminder Press the PLAY/ button or the STOP/ button to selectPlaying VHS Quasi Play Back SqpbRecording To stop recording, press the STOP/ button Tape SpeedsOne-Touch Recording Rerecording Tape Duplication Different brands of equipment may operate differentlyTimer Recording DailyTimer Recording cont’d Time OFF To Correct Press Clear To END Press ExitTimer Recording cont’d Checking or Clearing Timer Recordings With the TV/VCR on, press the Menu buttonDefeat Recording Repeat Play Insert a tape in the TV/VCR Press the Menu button Repeat PlayB Repeat Play cont’d Press the STATUS/EXIT button to remove the menu. A-BReal-Time Counter Memory Press the STATUS/EXIT button. The real-time counter willPlayback Options Forward and Reverse Searching SP/LP/SLPSuper High Speed Searching LP/SLP Viewing a Still PictureBlue Background GroundSleep Timer Press the SLEEP/WAKE UP buttonWake Up Timer Volume Bar Automatic Operation Features Specifications Glossary Helpful Hints Helpful Hints cont’d Limited Warranty TV/VCR CombinationIndex 23-24Page Page Supplied Accessories