Philips CCZ256AT Examine the lists on, Press the Number 5 button to select VCR PLUS+ REF

Page 40

CCZ256comb.QX33 4/6/99 9:14 PM Page 40

40 Setting Up the VCR Plus+ Programming System (cont’d)

2

Now, compare the channel numbers you have written in the VCR PLUS+ CH. and CABLE/TV CH. columns. You’ll notice that some stations have VCR Plus+ and Cable/TV channel numbers that are the same, and other stations have channel numbers that do not match. Where the channel numbers DO NOT match, you must tell the TV/VCR the VCR Plus+ and Cable/TV channel numbers according to the following steps.

Make each entry within 60 seconds of the previous entry.

3

Press the COMBI button, then press the MENU button.

2 Examine the lists on page 39.

POWER

 

EJECT

 

SLEEP

SPEED

MEMORY

 

REC/OTR

 

PAUSE/STILL

4

 

PLAY

 

REWF.FWD

STOP

MENU

STATUS/EXIT

CLEAR

1 2

45

78

A.CH 0

CABLE/DBS COMBI

VAR.SLOW

TRACKING

3

CH.

6

9

+100

VOL.

VCR PLUS+

/ENTER MUTE

F.ADV SLOW

7

6

5

43

Press the PLAY/button or the STOP/button to select VCR SETUP, then press the F.FWD/B button.

5

Press the Number 5 button to select VCR PLUS+ REF.

VCR PLUS+ CROSS REF. MAP

VCR PLUS+

CABLE/TV

124– –

125– –

01 – – – – B – –

02

– –

03

– –

TO SELECT CH PRESS CH ▲/▼

THEN ENTER CH NO.

TO END PRESS EXIT

SMART SMART SKIP INDEX PICTURE SOUND SEARCH SEARCH

6

Look at the lists you filled in on page 39. For stations whose

VCR Plus+ and Cable/TV channels do not match, press the CH(annel). Up/Down buttons until the arrow is beside the VCR Plus+ channel you need. Then, press the Number buttons to enter the corresponding Cable/TV channel from your list. (Enter a “0” before single-digit chan- nels.) Continue this process until you have entered all the stations on your list.

Note: If you are using a Cable Box/DBS, the Cable/TV channel will be 03 or 04 (the Cable Box/DBS output channel) for every VCR Plus+ channel. You must set the Cable Box/DBS to the channel you want to record; leave the Cable Box/DBS on for the timer recording.

VCR PLUS+ CROSS REF. MAP

VCR PLUS+ CABLE/TV

124– –

125– –

01

– – – – B

23

02

 

– –

03

 

– –

TO SELECT CH PRESS CH ▲/▼

TO DELETE PRESS CLEAR

TO END PRESS EXIT

7

Press the STATUS/EXIT button.

Helpful Hints

To correct a Cable/TV channel num- ber, repeat the steps on this page.

To clear a Cable/TV channel num- ber, repeat steps 3-5 on this page. Then, press the CH(annel)

Up/Down buttons to select it. Then press the CLEAR button. Press the STATUS/EXIT button.

Always enter a “0” before single- digit channels.

To select line input for the Cable/TV channel, press 0,0. A/V IN will appear on-screen.

Image 40
Contents CCZ256AT Dear Philips Magnavox product owner For Customer UseSafety Precautions FeaturesIntroduction Table of Contents Before Using the TV/VCR Hooking Up the TV/VCR Hook up your TV/VCR using one of the connections shownRod Antenna Hooking Up the TV/VCR cont’d AUDIO/VIDEO OUT Jacks on VCRAUDIO/VIDEO in Jacks on the rear of TV/VCR Crooked Pin Straight PinYou cannot set up channels if you are using a Cable Box Turning On the TV/VCRLanguage Selection Press the Combi button, then press the Menu buttonPress the Number 1 button to choose Select LAN GuageAlthough the TV/VCR may automatically memorize the channels Automatic Channel SetupChannels again by following the steps below Automatic Channel Setup cont’d Adding/Deleting ChannelsPress the Number 3 button to select ADD/DELETE Channel Programming of the channel you added or deleted will appearManual Clock Setting Setting the ClockPress the Number 6 button to select SET Clock Setting the Clock cont’d Press the Number 2 button to select SET Manual ClockPrimary Setup Automatic PBS Channel SelectionWait for the TV/VCR to find TimePress the Number 1 button to select SET PBS CH AutoManual PBS Channel Selection Press the PLAY/ button or the STOP/ button to selectUAL Find the timeUse the Number buttons to enter your PBS station. If you NOW Searching flashes on the TV/VCR screenDaylight-Saving Time Time Zone Press the Number 4 button to select SET Time ZoneSetting the Remote to Operate a Cable Box/DBS Cable BOX CodesDirect Broadcast System Codes Press the Mute buttonSetting the Remote to Operate a Cable Box/DBS cont’d Remote control againFront Panel Rear Panel Antenna HoleANTenna Jack Video in JackRemote Control Buttons VOLume. Up/Down Buttons PAUSE/STILL ButtonMemory Button REWind/ ButtonAdjusting the Picture Controls Smart Picture If another remote control beeps If another remote control beepsRemote Locator Press the Mute button, then press the PAUSE/STILL buttonOn Mode Counter only ModeOFF Mode ChannelReminder ReminderPlaying Insert a tape in the TV/VCRRecording Given belowPress the RECord/OTR button once to start recording To stop recording, press the STOP/ button Tape SpeedsOne-Touch Recording Different brands of equipment may operate differently Rerecording Tape DuplicationAudio and video cables are not included Timer Recording Select a once, daily or weekly recordingTimer Recording cont’d Rect informationPlease see page 58 for more Helpful Hints REVIEW. The timer recording information for the program Checking or Clearing Timer RecordingsLowest numbered position will appear on-screen. If no timer TV Channels Setting Up the VCR Plus+ Programming SystemStation Examine the lists on Press the Number 5 button to select VCR PLUS+ REFYou have completed the steps on pages 39 OutTimer Recording With the VCR Plus+ Programming System cont’d Record Defeat Follow the steps below to prevent accidental recordingPress the Number 4 button so that on appears beside Record DefeatSetting the Sleep Timer If the power fails, you might lose Sleep timer settingCaption Closed CaptionCAPTION1 Standard Closed Captions Closed Caption cont’dHalf-screen text To set the Volume BAR to on or OFF Smart SoundTo turn Smart Sound On or Off Press the Combi button, then press the Smart SoundPress the Number 2 button so that on appears beside Repeat PlayRepeat Play Repeat Play Insert a tape in the TV/VCRB Repeat Play cont’d Real-Time Counter Memory Appear on-screenIndex Search Tape in the TV/VCRAutomatic Operation Features Playback Options Forward and Reverse Searching SP/LP/SLPSuper High Speed Searching LP/SLP Viewing a Still PictureUnderstanding On-Screen Displays MTS Broadcast Stereo SystemSpecifically… MTS Broadcast Stereo System cont’d STEREO/SAPSpecifications GlossaryHelpful Hints Helpful Hints cont’d Please contact Philips at French Speaking English Speaking Limited WarrantyModel # Serial # Index CCZ256comb.QX33 4/6/99 914 PM CCZ256comb.QX33 4/6/99 914 PM Supplied Accessories