Philips CCZ256AT owner manual Specifications, Glossary

Page 57

CCZ256comb.QX33 4/6/99 9:14 PM Page 57

Specifications

General

CRT: 25-inch in line gun

Television system: NTSC-M

Closed caption system: Section 15.119, FCC (Federal Communications Commission) Standard

Video Heads: Four heads

Tape width: 1/2 inch (12.65 mm) Tape speed

SP: 33.35 mm/sec.

LP: 16.67 mm/sec.

SLP: 11.12 mm/sec.

Operating Temperature: 41˚F (5˚C) to 104˚F (40˚C)

Relative Humidity: 10% to 75%

Power requirement: AC 120V, 60Hz

Power consumption: 125W

Sound output: 1W+1W Dimensions:

24-1/2" (H) x 25-1/32" (W) x 20-3/32" (D)

622.5mm x 636 mm x 510 mm Weight: 70.4 lbs (32 kg)

Tuner Broadcast Channels

VHF 2-13, UHF 14-69

Cable TV Channels

2 – 13

Midband: A – 1

Superband: J – W

Hyperband: A-5 – A-1

Special Channel: 5A

Ultraband: 37 – 94, 100 – 125

Terminals

Antenna IN: VHF/UHF 75 ohms unbalanced

Video IN: RCA connector

Audio IN: RCA connector

Electrical Specifications

Video input level: 0.5~2.0Vp-p

Audio input level: -10dBv

Video S/N ratio

SP: More than 42dBµ

Audio S/N ratio

SP: More than 38dB

Designs and specifications are subject to change without notice and without our legal obligation.

Specifications / Glossary 57

Glossary

AUDIO IN Jacks: jacks located on the back of the TV/VCR which are used to record audio from another source.

Automatic Channel Setup: process in which the TV/VCR scans all available channels and places the ones you receive in its memory. Then, when you push the CH(annel). Up/Down buttons, you only scan through channels you receive.

Bands: settings that allow you to tune channels.

•Antenna – VHF (very high frequency; channels 2

-13) and UHF (ultra high frequency; channels 14

-69).

•Cable – all standard channels can be received without a Cable Box.

Brightness: adjusting increases or decreases the brightness of the color on-screen.

Color: adjusting pales or brightens the TV/VCR color.

Dubbing: copying a tape using a VCR.

HQ: high quality; a feature in the TV/VCR circuitry which provides enhanced picture detail.

Line Input: The channel to which you set your TV/VCR during dubbing. The line input channel is always channel 00 (A/V IN). To exit line input mode, press the CH(annel). Up/Down buttons or the Number buttons to select another channel.

Mode: a TV/VCR operation.

OTR: One-Touch Recording; programming a timed recording that starts immediately and records for 30 minutes to eight hours, whichever you specify.

Picture: adjust to increase or decrease the con- trast of the picture on-screen.

Sharpness: adjusting softens or clarifies the picture on the TV screen.

Tape Speeds: how fast the tape travels during playback or recording.

•SP (standard play) – fastest tape speed (record- ing time for a T120 tape is approximately two hours); best picture quality.

•LP (long play) – average tape speed (recording time for a T120 tape is approximately four hours).

•SLP (super long play) – slowest tape speed (recording time for a T120 tape is approximately six hours).

Tint: adjusting changes the tints of the picture on the TV/VCR from purple to green.

VCR: video cassette recorder.

VIDEO IN Jack: jack located on the back of the TV/VCR which is used to record video from anoth- er source.

Page 56 Page 58
Image 57
Page 56 Page 58
Contents CCZ256AT For Customer Use Dear Philips Magnavox product ownerFeatures Safety PrecautionsIntroduction Table of Contents Before Using the TV/VCR Hook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna AUDIO/VIDEO OUT Jacks on VCR Hooking Up the TV/VCR cont’dAUDIO/VIDEO in Jacks on the rear of TV/VCR Crooked Pin Straight PinTurning On the TV/VCR You cannot set up channels if you are using a Cable BoxPress the Combi button, then press the Menu button Language SelectionPress the Number 1 button to choose Select LAN GuageAutomatic Channel Setup Although the TV/VCR may automatically memorize the channelsChannels again by following the steps below Adding/Deleting Channels Automatic Channel Setup cont’dPress the Number 3 button to select ADD/DELETE Channel Programming of the channel you added or deleted will appearSetting the Clock Manual Clock SettingPress the Number 6 button to select SET Clock Press the Number 2 button to select SET Manual Clock Setting the Clock cont’dAutomatic PBS Channel Selection Primary SetupTime Wait for the TV/VCR to findPress the Number 1 button to select SET PBS CH AutoPress the PLAY/ button or the STOP/ button to select Manual PBS Channel SelectionFind the time UALUse the Number buttons to enter your PBS station. If you NOW Searching flashes on the TV/VCR screenDaylight-Saving Time Press the Number 4 button to select SET Time Zone Time ZoneCable BOX Codes Setting the Remote to Operate a Cable Box/DBSDirect Broadcast System Codes Press the Mute buttonRemote control again Setting the Remote to Operate a Cable Box/DBS cont’dFront Panel Antenna Hole Rear PanelANTenna Jack Video in JackRemote Control Buttons PAUSE/STILL Button VOLume. Up/Down ButtonsMemory Button REWind/ ButtonAdjusting the Picture Controls Smart Picture If another remote control beeps If another remote control beepsRemote Locator Press the Mute button, then press the PAUSE/STILL buttonCounter only Mode On ModeOFF Mode ChannelReminder ReminderInsert a tape in the TV/VCR PlayingGiven below RecordingPress the RECord/OTR button once to start recording To stop recording, press the STOP/ button Tape SpeedsOne-Touch Recording Rerecording Tape Duplication Different brands of equipment may operate differentlyAudio and video cables are not included Select a once, daily or weekly recording Timer RecordingRect information Timer Recording cont’dPlease see page 58 for more Helpful Hints Checking or Clearing Timer Recordings REVIEW. The timer recording information for the programLowest numbered position will appear on-screen. If no timer Setting Up the VCR Plus+ Programming System TV ChannelsStation Press the Number 5 button to select VCR PLUS+ REF Examine the lists onOut You have completed the steps on pages 39Timer Recording With the VCR Plus+ Programming System cont’d Follow the steps below to prevent accidental recording Record DefeatPress the Number 4 button so that on appears beside Record DefeatIf the power fails, you might lose Sleep timer setting Setting the Sleep TimerClosed Caption CaptionCAPTION1 Closed Caption cont’d Standard Closed CaptionsHalf-screen text Smart Sound To set the Volume BAR to on or OFFTo turn Smart Sound On or Off Press the Combi button, then press the Smart SoundRepeat Play Press the Number 2 button so that on appears besideRepeat Play Insert a tape in the TV/VCR Repeat PlayB Repeat Play cont’d Appear on-screen Real-Time Counter MemoryTape in the TV/VCR Index SearchAutomatic Operation Features Forward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still PictureMTS Broadcast Stereo System Understanding On-Screen DisplaysSpecifically… STEREO/SAP MTS Broadcast Stereo System cont’dGlossary SpecificationsHelpful Hints Helpful Hints cont’d Limited Warranty Please contact Philips at French Speaking English SpeakingModel # Serial # Index CCZ256comb.QX33 4/6/99 914 PM CCZ256comb.QX33 4/6/99 914 PM Supplied Accessories
Top Page Image Contents