Philips CCX133AT warranty On-Screen Status Displays, On Mode

Page 26

26 On-Screen Status Displays

A status display, which includes the current time, channel, and other information (see illustration of the status display at right), will appear when you press the STATUS/EXIT button or certain function buttons. You can bring up the status display at any time by pressing the STATUS/EXIT button. Remove the status display by pressing this button again. The contents of the status display may vary.

ON MODE:

●Whenever a function button (REW(ind)/-, PLAY/▲, etc.) is pressed, the status display will appear for five seconds.

COUNTER ONLY MODE:

●When a function button (REW(ind)/-, Play/▲, etc.) is pressed, the status display will appear for five seconds. After five sec- onds, only the counter will remain on-screen. To remove it, choose ON or OFF in the ON-SCREEN MODE menu. (There is an exception. When you press the STOP/▼ button, the sta- tus display will appear for five seconds, then disappear.)

OFF MODE:

●The status display will not appear when you press a function button. The channel number will appear briefly when you select a channel if channels are programmed.

To choose an ON-SCREEN MODE, follow the steps below.

						Function
Channel						Button
	Time					Pressed
	Time

		12:00 AM				STOP
		CH10
			SLP		M 1:23:45

	Tape				Counter
	Speed				and
					Counter
					Memory

1

Press the MENU button to display the pop up menu.

2

Press the PLAY/▲ button or the STOP/▼ button to select

VCR SETUP. Then, press the F.FWD/+ button.

3

Press the Number 3 button to select ON-SCREEN MODE.

4

Press the Number 1 button to select ON, the Number 2 button to select COUNTER ONLY, or the Number 3 but- ton to select OFF. Your selection will appear on-screen.

5

Press the STATUS/EXIT button.

Helpful Hints

•If the channel you select has no broadcast, the screen will be solid blue. The screen will remain blue until you select an active channel.

•Channel numbers (when tuned) appear on-screen for a few seconds.

•The channel number will remain on- screen at all times (except during tape playback) if REMINDER is set to ON. Details are on page 27.

•You cannot view closed captions of a tape when the TV/VCR is in Counter Only mode. The counter display will replace the closed captioning display on the TV/VCR screen. Details are on pages 42 - 43.

Image 26

Contents CCX133AT Dear Philips Magnavox product owner For Customer UseIntroduction FeaturesSafety Precautions Table of Contents VCR Maintenance Putting Batteries in the Remote ControlUsing the Remote Control Removing the Shipping CardRod Antenna Hook up your TV/VCR using one of the connections shownHooking Up The TV/VCR Crooked Pin Straight Pin Hooking Up The TV/VCR cont’dBent pin Cable PlugTurning On the TV/VCR Language Selection Press the Menu button to display the pop up menuChannel Memory Enter the channel number you want to add or delete Adding/Deleting ChannelsPress the Number 3 button to select ADD/DELETE Channel Press the Menu buttonChannels are programmed. Details are on pages 10 Setting the ClockManual Clock Setting Press the Number 6 button to select SET ClockSetting the Clock cont’d Press the Number 2 button to select SET Manual ClockPress the Menu button to display the pop up menu Setting the Clock cont’dAutomatic PBS Channel Selection Press the Number 1 button to select SET PBS CH Wait for the TV/VCR to findTime Manual PBS Channel Selection NOW Searching flashes on the TV/VCR screen Find the timeUse the Number buttons to select your PBS station Daylight-Saving Time Press the PLAY/ button or the STOP/ button to selectYou cannot select Time Zone at if Auto Clock is set to OFF Time ZonePress the Number 4 button to select SET Time Zone Front Panel Connect your antenna or cable here Rear PanelANTenna Jack Details are on pages six sevenRemote Control Buttons Channel Up/Down Buttons Volume Up/Down ButtonsALT. CH Alternate Channel Button Mute ButtonAdjusting the Picture Controls Press the REWind/- button to decrease a picture control Decrease IncreaseDecreased brightness On Mode On-Screen Status DisplaysReminder Playing Press the RECord/OTR button once to start recording RecordingSpeed are given below Recording options are on pages 30You can not pause an OTR One Touch RecordingOTR Audio and video cables are not included Rerecording Tape DuplicationDifferent brands of equipment may operate differently Timer Recording Select a once, daily or weekly recordingTimer Recording cont’d Timer Recording cont’d Checking or Clearing Timer Recordings Local TV Stations Call letters Setting Up the VCR Plus+ Programming SystemTV Channels Cable Channels Press the STATUS/EXIT button to exit Examine the lists onPress the Number 5 button to select VCR PLUS+ REF. MAP Press the VCR PLUS+ button on the remote control. The on Screen display shown below will appearTimer Recording With the VCR Plus+ Programming System cont’d Follow the steps below to prevent accidental recording Record DefeatRecord Defeat Setting the Sleep Timer If the power fails, you might lose the sleep timer settingMenu Closed CaptioningExample ScreenText Screen Closed Captioning cont’dStandard Closed Captioning To turn Volume Bar On or Off Volume Bar / Smart SoundVolume Bar Smart SoundRepeat Playback B Repeat Playback Insert a tape in the TV/VCRRepeat Playback cont’d Appear on-screen Button to reset the real time counter to zeroReal Time Counter Memory While the counter remains on-screen, press the ClearAutomatic Operation Features Super High Speed Searching LP/SLP Playback OptionsForward and Reverse Searching SP/LP/SLP Viewing a Still PictureSpecifications GlossaryHelpful Hints Helpful Hints cont’d Model # Serial # Limited WarrantyPlease contact Philips at French Speaking English Speaking Index Supplied Accessories