Philips SVZ142 owner manual Glossary, Cable Box/DBS Output Channel Channel 3 or

Page 44

SVZ142.comb 4/7/99 6:30 PM Page 44

44 Glossary

AUDIO IN/OUT Jacks: jacks located on the back of the VCR which are used to record audio from another source (IN) or to send audio to another source (OUT).

Automatic Channel Setup: process in which the VCR scans all available channels and places the ones you receive in its memo- ry. Then, when you push the CHANNEL (o/p) buttons, you only scan through channels you receive.

Bands: settings that allow you to tune channels.

•Antenna – VHF (very high frequency; channels 2-13) and UHF (ultra high frequency; channels 14-69).

•Cable – all standard channels can be received without a Cable Box/DBS.

Cable Box/DBS Output Channel: Channel 3 or 4.

Dubbing: copying a tape using a second VCR.

Frame: a single still picture.

HQ: high quality; a feature in the VCR circuitry which provides enhanced picture detail.

Line Input: The channel to which you set your VCR during dub- bing. The line input channel is always channel 00.

If you accidentally enter Line Input mode (AUX will appear on your TV screen briefly), press the CHANNEL (o/p) buttons or use the Number buttons to select another channel.

Mode: a VCR operation.

OTR: One-Touch Recording; programming a timed recording that starts immediately and records for 30 minutes to eight hours, whichever you specify.

Remote Control: the small electronic unit that came with your VCR; allows you to operate your VCR from a distance.

RF coaxial cable: The cable supplied with your VCR. Use it to connect your VCR to your TV (or Cable Box/DBS, if applicable). The supplied cable is a snap-on type. However, you may also use a screw-on type if you prefer.

Special Effects: forward and reverse searching; viewing a still picture; slow motion playback.

Tape Speeds: how fast the tape travels during a recording.

•SP (standard play) – fastest tape speed (recording time for a T120 tape is approximately two hours); best picture quality.

•LP (long play) – average tape speed (recording time for a T120 tape is approximately four hours).

•SLP (super long play) – slowest tape speed (recording time for a T120 tape is approximately six hours).

VCR: video cassette recorder.

VIDEO IN/OUT Jacks: jacks located on the back of the VCR which are used to record video from another source (IN) or to send video to another source (OUT).

Page 43 Page 45
Image 44
Page 43 Page 45
Contents Video Cassette Recorder Warranty Verification For Customer UseIntroduction FeaturesSafety Precautions Table of Contents Before Using Your VCR Putting Batteries in the Remote ControlUsing the Remote Control VCR maintenanceHookups Without a Cable Box/Direct Broadcast System Disconnect the antenna or cable from your TVHookups Without a Cable Box/Direct Broadcast System cont’d Timer Recordings Hookups With a Cable BoxRecording and Viewing a Scrambled or Unscrambled Channel Watching TV With the VCR OffPlaying a Tape Hookups With a Cable Box cont’dRecording One Channel/Watching Another Hookups With a Stereo TV Turning on Your VCR 2Turn on the TVAutomatic Channel Setup Select ADD/DELETE CH. Then, press the F.FWD button Automatic Channel Setup cont’dAdding/Deleting Channels Setting the Clock Follow the steps below to set your VCR’s clock. Make sureSetting the Clock cont’d Press the Counter RESET/EXIT button to exit Language SelectionOFF mode Press the Display button once Count mode Press the Display button once Clock modeOn-Screen Status Displays Press the DisplayRemote Control Buttons Counter RESET/EXIT Button Eject ButtonTime Search Button Index Search ButtonVCR Display Panel Front Panel AC Power Cord Rear PanelVideo OUT Jack Video in JackPlaying Read and follow the steps below to play a tapeRecording 1Turn on the TV Insert a tapeStopping an OTR One-Touch RecordingStarting an OTR Timer Recording Program Number Once Daily →WEEKLYTimer Recording cont’d Repeat the procedure in to set the recording’s end timeTimer recording. Details are on page eight Press the Counter RESET/EXIT buttonCancelling a Timer Recording Correcting a Timer RecordingAuto Return Auto Satellite Link Using a Satellite Tuner Press the VCR/TV button on the VCR remote control to Recording One Channel/Watching AnotherTo return to the channel being recorded, use the TV Put the VCR in VCR position. The VCR/TV light will appearRerecording Tape Duplication JackRepeat Play Special Effects Playback Forward and Reverse Searching SP/LP/SLPSuper High Speed Searching LP/SLP Viewing a Still PictureTo on or OFF Rental PlayMenu will disappear, and Rental on or Rental Real-Time Counter Memory Press the Play button to watch the tapeIndex Search Time Search Time Search is not available during recordingQuick Find To resume normal tape playback, press the Play buttonAutomatic Playback Features Helpful Hints Helpful Hints cont’d Glossary Cable Box/DBS Output Channel Channel 3 orSpecifications Limited Warranty Video Cassette RecorderIndex Supplied Accessories
Top Page Image Contents