Philips SVZ142 Before Using Your VCR, Putting Batteries in the Remote Control, Erasure Prevention

SVZ142.comb 4/7/99 6:30 PM Page 5

Before Using Your VCR 5

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by sliding the lid in the direction of the arrow.

2

Insert two AA batteries inside the battery compartment with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Using the Remote Control

●Point the remote control at the VCR’s remote sensor (see page

21)when using the remote control to operate the VCR.

●Do not put objects between the remote control and the VCR.

1

2

3

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings are not erased accidentally.

1

To prevent accidental erasure, break off the tab with a screwdriv- er.

2

To record again, cover the hole with cellophane tape.

VCR maintenance

●In this VCR, use only tapes with the mark.

●Make sure any light adhesive stick-on notes are removed from the video cassette tape before putting the tape in the VCR. Removable labels like these can jam the VCR.

●Periodic maintenance is required to maintain your VCR’s per- formance. The video heads will eventually require cleaning or replacement. Cleaning or replacement of the video heads should be performed by an authorized service center.

1

2

Helpful Hints

•The remote control and its batteries are supplied.

•Do not mix alkaline and man- ganese batteries.

•Do not mix old and new batteries.