SECTION SIX: CARE AND MAINTENANCE
Do-It-Yourself Maintenance
OVEN LIGHT BULB REPLACEMENT
Replace only with a
TO REPLACE THE LIGHT BULB:
1.Turn oven light switch to the off position. Let bulb and cover cool completely.
2.Remove the light cover.
3.Remove the
4.Replace cover. (See Caution).
CAUTION:
Before replacing the light bulb, be certain the Oven Light Switch is in the off posi- tion. Let bulb and cover cool completely before touching. If the light bulb glass comes loose from the base, turn the power to the oven OFF at the circuit breaker panel, before attempting to remove the bulb base from the socket.
POWER FAILURE
In the event of a power failure, only the standard burners can be lighted manually. It is necessary to light each standard burner individually.
If the range's cooktop is being used when the power failure occurs, turn all of the burner control knobs to the OFF position. Then, the standard burners can be lighted by holding a match at the ports and turning the
control knob to the 
position. Wait until the flame is
burning all the way around the burner cap before adjusting the flame to the desired height.
The two ExtraLow® burners on the left side cannot be used during a power failure. Be sure to turn them OFF if a power failure occurs because they will not turn back on until both control knobs are turned OFF and then turned back on again. See "What to do if you Smell Gas", on the inside front cover.
If you have low gas pressure, contact your gas company.
INTERMITTENT OR CONSTANT IGNITER SPARKING
Intermittent or constant sparking of the sealed gas surface burners can result from a number of preventable conditions. Eliminate these conditions as indicated in the chart.
SYMPTOM | CAUSE | |
Intermittent sparking | • | Ceramic igniter is wet or dirty. |
| • | Burner ports are clogged. |
REMEDY
•Carefully dry or clean igniter.
•Clean ports on burner cap with a wire, a needle or straightened paper clip.
More than four clicks of | • | Improper fit of burner cap onto |
igniter before lighting |
| burner base. |
Constant Sparking | • | Range is not properly grounded. |
•Align burner cap properly on burner base.
•Refer to Installation Instructions. Have a qualified electrician ground the range properly.
• Electrical power supply is | • Refer to Installation Instructions. |
incorrectly polarized. | Have a qualified electrician |
| ground the range properly. |
34
