VRZ360 4/7/99 9:53 PM Page 8
8 Hookups With a Cable Box/Direct Broadcast System
There are two ways to connect your Cable Box/DBS to the VCR. With this connection:
•You may view any channel.
•You must select channels at the Cable Box/DBS. Channels cannot be changed at the VCR.
•You may not view a channel other than the one you are recording.
•You may not set up channels at the VCR.
•You can only program a timer recording for one channel at a time. Set the TV and the VCR to the Cable Box/DBS output channel (channel 03 or 04), and set your Cable Box/DBS to the channel you want to record. When you enter the channel you want to record in a timer recording, select channel 03 or 04 (the Cable Box/DBS output channel). (This is step 3 on page 36.) Leave the Cable Box/DBS on for a timer recording.
1 |
|
| 2 | VCR |
Cable Box/DBS |
| |||
|
| |||
IN | OUT |
|
| |
Cable signal
IN OUT ANT.IN 
R 
AUDIO
L
RF OUT
VIDEO
CH3 CH4
75Ω ANT / CABLE
TV’s 3 ANTENNAIN jack
RF coaxial cable
RF coaxial cable
Connections
1
Connect a Cable signal to the IN jack on the Cable Box/DBS.
2
Use an RF coaxial cable (supplied) to connect the OUT jack on the Cable Box/DBS to the ANT(enna) IN jack on the VCR.
3
Use a second RF coaxial cable to connect the RF OUT jack on the VCR to the TV’s ANTENNA IN jack.
Recording/Viewing Any Channel
1
With the VCR on and in VCR position (the VCR light will appear on the display panel), use the CH(annel) 8/9 buttons to set the VCR to the Cable Box/DBS output channel (channel 03 or 04).
2
Set the TV to the same channel to which you set the VCR.
3
Select the channel you want to view/record at the Cable Box/DBS.