Philips VRX364AT warranty Timer Recording cont’d, Enter the recording’s stop time

Timer Recording (cont’d) 35

4

Use the Number buttons (1 - 8) to select a slot in which to store the timer recording. There are eight timer recording slots. Open slots will flash on-screen.

NOTE: If you enter a number for a slot that has already been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on- screen for a few seconds. Then information about the program in that slot will be displayed on-screen. If this happens, press the STATUS/EXIT button twice. Then start again at step 1.

5

Enter the channel you want to record.

●If you have a basic antenna or cable hookup (as shown on pages six-seven) enter the channel of the TV program you want to record. (You must enter a 0 before all single digit channels.)

●If you are recording from line input, press 0, 0. AV REAR will appear on-screen.

●If you are using a Cable Box/DSS Receiver, enter the Cable Box/DSS Receiver output channel (channel 03 or 04). See page eight for details.

ONE TIME PROGRAM

PROGRAM	1
CHANNEL	– –

TO CORRECT PUSH CLEAR

TO END PUSH EXIT

6

Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM	1
CHANNEL	10
TIME ON	– – : – –

TO CORRECT PUSH CLEAR

TO END PUSH EXIT

POWEREJECT

SLOW

PAUSE/STILL

PLAY

– REW F.FWD +

STOP

STATUS/EXIT CLEAR MENU

SPEED MEMORY

REC/OTRJOG&

SHUTTLE

VCR TV CBL/DSS MUTE

1 2 3

VOLUME

4 5 6

7 8 9

CHANNEL

0 +100

VCR PLUS+

/ENTER

TIME	VAR. SLOW
VCR/TV SEARCH

4-7

7

Enter the recording’s stop time.

Follow the instructions in step 6 to set the recording’s stop time (AM or PM will be set automatically).

ONE TIME PROGRAM

PROGRAM	1
CHANNEL	10
TIME ON	09:30 PM
TIME OFF	– – : – –

TO CORRECT PUSH CLEAR

TO END PUSH EXIT

Instructions continue on page 36.

Helpful Hints

•You must leave the Cable Box/DSS Receiver turned on for a timer recording (if applicable).

•Entries that do not match the VCR’s internal clock or calendar will cause a question mark (?) to appear on- screen.