Philips VRX364AT warranty Timer Recording With the VCR Plus+ Programming System cont’d

Page 41

Timer Recording With the VCR Plus+ Programming System (cont’d) 41

5

Press the Number 1 button to record in SP speed, the Number 2 button to record in LP speed, or the Number 3 button to record in SLP speed. Your selection will appear to the right of REC SPEED on-screen, although SP=1 LP=2 SLP=3 will continue to flash. For details about tape speed, see pages 36 and 56. You cannot use the (Tape) SPEED button at this time.

ONE TIME PROGRAM

PROGRAM

1

CHANNEL

09

TIME ON

10:30 PM

TIME OFF

11:30 PM

REC SPEED

SLP

SP=1 LP=2

SLP=3

START DATE

10/10/97

 

FRI.

TO END PUSH EXIT

6

Press the STATUS/EXIT button. PROGRAM WAS COM-

PLETED / PLEASE TURN OFF VCR FOR TIMER RECORDING should appear on the screen. After three seconds, the on-screen display will disappear.

7

Press the POWER button to turn off the VCR power. The Timer light will appear. The Timer light will flash if there is not a tape in the VCR.

If the timer recording will take place several hours or days from now, you may use the VCR until time for the recording. Just turn off the VCR a few minutes before the recording starts.

The VCR must be turned off for a timer recording to take place. If you forget to turn off the VCR, PLEASE TURN OFF VCR FOR TIMER RECORDING flashes on your TV screen two minutes before a timer recording starts. You can remove the mes- sage by pressing the CLEAR button.

The VCR must be off for a

timer recording to take

place! Make sure there is a

tape in the VCR.

7

POWER

EJECT

 

 

SLOW

 

PAUSE/STILL

 

 

PLAY

–

REW

F.FWD +

6

STOP

STATUS/EXIT

CLEAR

 

MENU

SPEED

MEMORY

REC/OTRJOG&

SHUTTLE

5

VCR

TV

CBL/DSS MUTE

1

2

3

 

 

VOLUME

4

5

6

 

7

8

9

 

 

 

CHANNEL

 

 

0

+100

 

VCR PLUS+

 

 

 

/ENTER

 

 

 

 

TIME

VAR. SLOW

 

VCR/TV SEARCH

Helpful Hints

•To exit the VCR Plus+ programming system at any time, press the STA- TUS/EXIT button. The display will disappear from the TV screen.

•If the preset time for a timer recording comes up during an OTR, the OTR has priority.

•To stop a started timer recording, press the STOP/EJECT button on the VCR.

•If the power fails for more than one minute, programmed timer record- ings may be lost. Reset the clock before re-programming the timer recordings.

•If you are using a Cable Box/DSS Receiver, timer recordings are pro-

grammed differently. See page eight for details.

See page 54 for more hints.

Page 40 Page 42
Image 41
Page 40 Page 42
Contents Video Cassette Recorder VRX364AT TM For Customer Use Dear Philips Magnavox product ownerSafety Precautions FeaturesIntroduction UseTable of Contents Using the Remote Control Putting Batteries in the Remote ControlVCR maintenance Erasure PreventionDisconnect the antenna or cable from your TV Hookups Without a Cable BoxPlug in the TV and the VCR Hookups Without a Cable Box cont’dHookups With a Cable Box/Digital Satellite System Timer RecordingsRecording/Viewing Any Channel Watching TV With the VCR OffPlaying a Tape Recording One Channel/Watching AnotherNel Press the Play button to play the tapeHookups With a Stereo TV 2Turn on the TV Turning on Your VCRChannel Memory Press the Number 3 button to select Tuner SET UPProgramming Channels Press the VCR buttonUse the Number buttons to enter the channel number Adding/Deleting ChannelsReviewing Programmed Channels Manual Clock Setting Setting the ClockPress the Number 4 button to select SET Clock Press the Number 2 button to select SET Manual ClockSetting the Clock cont’d Automatic Clock Setting Setting the Clock cont’dPress the VCR button, then press the Menu button to Bring up the main menu displayPress the Number 4 button to select SET Time Zone Time ZoneDaylight-Saving Time Selection Daylight-Saving Time SelectionLanguage Selection Press the Number 2 button to select VCR SET UPLanguage Selection Press the Number 4 button to select LanguagePress and release the Mute button Setting the Remote to Operate a TV2Find your 1&6 TV code Satellite Find yourSystem CodeRemote Control Buttons Slow Button FWD Fast Forward ButtonREWind Button Menu ButtonVolume Up/Down Buttons Remote Control Buttons cont’dPress to increase or decrease the TV’s volume Clear ButtonPWRpower. Light Timer LightClock/Feature Display VCR Display PanelPress to turn the VCR power on and off Power ButtonFront Panel STOP/EJECT ButtonPause Button Front Panel cont’dRemote Sensor Rear Panel To choose the status display mode, follow the steps below Press the Number 2 button to select on Screen ModePressed Broadcast1Turn on the TV 2Insert a tape in the VCR PlayingRead and follow the steps below to play a tape Recording Press the VCR button on the remote controlPress the Stop button to stop the recording Recording One Channel/Watching AnotherStart a recording see Press the VCR button One Touch Recording Daily Timer RecordingRecording Menu ScreenEnter the recording’s stop time Timer Recording cont’dTape Speeds Press the STATUS/EXIT button. Program WAS COMSee page 54 for more hints Checking or Cancelling Timer RecordingsMenu button Press the Number 1 button to select Program Local TV Stations Call letters Setting Up the VCR Plus+ Programming System TV Channels Cable Channels Examine the lists on Press the Number 5 button to select VCR PLUS+ REF. MAPTimer Recording With the VCR Plus+ Programming System Timer Recording With the VCR Plus+ Programming System cont’d Rerecording Tape Duplication Repeat Playback Repeat PlaybackTime Search Time SearchReal Time Counter Memory Real Time Counter MemoryForward and Reverse Searching SP/LP/SLP Special Effects PlaybackSuper High Speed Searching LP/SLP Viewing a Still PictureViewing a Slow Motion Picture Special Effects Playback cont’dViewing a Picture in Slow to Fast Motion Play button or press the Slow button againAutomatic Tracking Adjustment Automatic Operation FeaturesAutomatic Playback Automatic Rewind, Eject, OffManual Tracking Automatic Operation Features cont’dUnderstanding On-Screen Displays MTS Broadcast Stereo SystemSpecifically… MonoPress the RECord/OTR button to start recording MTS Broadcast Stereo System cont’dPress the VCR button, then press the Menu button See page 55 for more hints Hi-Fi Stereo Sound SystemPress the Number 3 button to select Audio OUT Hi-Fi Stereo Sound System cont’d Helpful Hints Helpful Hints cont’d Cable Box/DSS Receiver Output Channel Channel 03 or GlossarySpecifications Renewed Index Supplied Accessories
Top Page Image Contents