Philips VRA451, VRA651 owner manual Timer Recording with the VCR Plus+ Programming System

34 Timer Recording with the VCR Plus+ Programming System

Follow the steps below to program a timer recording using PlusCode programming numbers. Before you begin make sure:

•Channels are set up. Details are on pages 11-12.

•The clock is set. Details are on pages 13-17.

•There is a tape in the VCR. Make sure the tape’s record tab is intact and the tape is long enough to record the program(s).

•The VCR is in VCR position (the VCR light will appear on the display panel). If the VCR light does not appear, press the VCR/TV button once.

•You have programmed the VCR Plus+ and Cable/TV channel numbers. Details are on pages 32-33.

Complete each step within 60 seconds of completing the previous step. If you don’t, you may start again at step 1.

1

Press the VCR button.

2

Press the TIMER button.

SELECT , 9 CHOOSE >/OK

→VCR PLUS+

QUICK PROGRAMMING PROGRAM REVIEW

TO END PUSH EXIT

3

Press the PLAY 8 or STOP 9 button to select VCR PLUS+, then press the FF :/OK button.

VCR PLUS+ PROG. CODE

VCR PLUS+ L

TO END PUSH EXIT

4

Use the Number buttons to enter the PlusCode program- ming number of the program you wish to record. (This number is different for every program.)

CBL / DBS		TV		VCR
VCR/TV		POWER		EJECT
QUICK PROGRAMMING
1	+	2	+	3
START	.............	STOP	.............	DATE
4	-	5	-	6
DBS		DAILY		WEEKLY
7		8		9
SPEED		0		CLEAR
	STILL/SLOW
..-		........ +
REW				FF
		PLAY
				/OK
		STOP
VOL		MENU		CH
	EXIT/STATUS
		TIMER
SKIP SEARCH		INDEX		AUDIO/MUTE
SMARTPICTURE				REC /OTR

1

4

3

2

VCR PLUS+ PROG. CODE

VCR PLUS+ 1234L

TO SET PUSH >/OK

TO CORRECT PUSH CLEAR TO END PUSH EXIT

Helpful Hint

•If you enter an incorrect PlusCode programming number at step 4, ERROR-RE-ENTER CODE will flash on the screen after step 5. Enter the correct PlusCode programming num- ber.