7 | Switch off with STANDBY/ON . |
| The programmed recording will only function when the video |
| recorder is switched off with STANDBY/ON . |
| If any of the TIMER blocks are in use, ' ' will light up on the video |
| recorder display. |
Problem solving for programmed recordings
ENGLISH
PROBLEM
The video recorder does not react
'SWITCH TO STANDBY- TIMER RECORDING' flashes on
the TV screen
A cassette was automatically ejected during recording
Error message: 'NO CASSETTE' ' ' will
flash in the video recorder display
The 'PROTECTED
CASSETTE' error message appears briefly on the screen then the cassette is ejected
SOLUTION
While a programmed recording is being made, you cannot operate your video recorder manually. If you want to cancel the programmed recording, press STANDBY/ON .
The video recorder was switched on several minutes before the start of a programmed recording. Switch off the video recorder with STANDBY/ON . A programmed recording (timer) will only function if the video recorder is switched off.
The end of the tape was reached during recording.
No cassette was inserted. Insert a cassette and switch off the video recorder using
STANDBY/ON .
A cassette was inserted with the security tab removed. Undo the erase protection (chapter 'Manual Recording', section 'Preventing accidental erasing of cassettes') or insert a different cassette.
Error message: 'ALL
TIMERS OCCUPIED'
The 'DATA ERROR' message appears on the screen
If this error message appears after pressing TIMER , then all TIMER blocks are already programmed. No more recordings can be programmed. If you want to clear or check a
programmed recording (TIMER block), select it with P { or P | . |
The data for the recording could not be transferred. Please check date, start time and end time of the programmed recording.
Programming a recording (TIMER) | 39 |
|