Extron electronic EDID 101V Installation and Operation, cont’d Panel Features, Side panel

Installation and Operation, cont’d

Panel Features

EDID 101D

DVI OUTPUT (DISPLAY)

g

CONFIG

VGA OUTPUT (DISPLAY)

	ON
	1	2
	60	DIGITAL
RECORD	Hz	SIGNAL
	50	ANALOG

a b c d

	ON
	1	2
	60
RECORD	Hz	SPARE
	50

EDID

SELECT

EDID 101V

EDID

SELECT

DVI INPUT (SOURCE)

POWER 12V

0.4A MAX

e f

VGA INPUT (SOURCE)

POWER 12V

0.4A MAX

EDID 101 Panel views

Side panel

A

B

Power LED — Dual-color multi-purpose LED:

Green — Indicates power is connected from the 5 VDC pin of a DVI/VGA video source or by the optional 12 VDC power supply (E).

Flashing red — During the recording process, indicates a new EDID being written to memory, returning to solid green when the write completes.

Record button — This recessed button is used to initiate recording of a connected display device EDID to

user‑programmable memory (position 0 on the rotary switch).

C	DIP switch — Position 1 is used to select the vertical refresh
	frequency for the pre-programmed EDID. When switched to
	"Off", the EDID selected by rotary positions 1 through F are
	based on 50 Hz. When switched to "On", they are based on
	60 Hz (default position).
	Position 2, (not used on EDID 101V; labeled "Spare"), selects the
	signal format, digital or analog, for the pre-programmed EDID.
D	EDID Rotary Switch — Position 0 of this 16 position rotary
	switch is used to record an EDID from a display.
	Positions 1-F select pre‑programmed EDID resolutions.
	N Configuring the EDID 101 rotary and DIP switches
	allow a user to select a pre-programmed EDID based on
	the native rate of a display (i.e. 1280x1024 @ 60 Hz)
	and a desired signal type (i.e. digital), but does not
	necessarily force a video source to output that rate. Since
	EDID is not limited to reporting a single video rate
	(i.e. the native rate), each Extron EDID also lists other
	common video rates for use by the video source.

8EDID 101D/EDID 101V • Installation and Operation