Chapter 2: Overview
•19-inch rackmount brackets
•User manual
2.4 Hardware Description
Figures 2-1 and 2-2 show the front panel of the switch, and Figure 2-3 shows its back panel. Tables 2-1 and 2-2 describe the components.
2.4.1 Front Panel
1 | 3 | 2 | 6 | 5 | 4 | 7 |
Figure 2-1. Front-panel diagram #1.
9 | 11 | 12 | 13 | 8 | 10 | 14 |
Figure 2-2. Front-panel diagram #2.
Table 2-1. Front-panel components.
Number | Component | Description | |
|
|
| |
1 | Power Switch | The power switch turns the unit on and off. The LED will light red to indicate that the switch is on and is receiving power. The | |
switch will remember that last state during a power cycle. When power is removed and restored, the last configuration will be used. | |||
|
| ||
|
|
| |
2 | Input Status Display | Input sources 1 to 4 LEDs light blue to indicate that a video source is present on that input. | |
|
|
| |
3 | Output Status Display | Each output (destination) channel shows which input (source) is assigned. | |
|
|
| |
4 | Destination Select Buttons | Separate outputs 1 through 4 select buttons are provided for each destination assignment. | |
|
|
| |
5 | Source Select Buttons | Separate inputs 1 through 4 select buttons are provided for each source selection. Source buttons 1 and 2 are used to change EDID | |
modes when the EDID button is pressed. | |||
|
| ||
|
|
| |
6 | IR Sensor | The IR sensor receives IR commands from the supplied remote control or | |
|
|
| |
|
| Disables (mute) video on all destinations OR selects the same source to all destinations. | |
7 | Function Key — ALL | Option 1: Press ALL followed by the OFF button. The display will show “0,” indicating that all destinations have no video selected. | |
Option 2: Press ALL followed by Source 1 through 4. The display will show the source selected. | |||
|
|
Press ENTER and the preset source selection will be assigned to all destinations.
Page 10 |