Lumex Syatems FR587WH operating instructions Heat and Massage Unit Operation Instructions

Page 16

9.Insert the Y-cable connector labeled UPPER into the back cushion cable connector also labeled UPPER until its locking tabs snap into place, as shown at right.

10.Insert the Y-cable connector labeled LOWER into the back cushion cable connector also labeled LOWER until its locking tabs snap into place, as shown at right.

11.Insert the Y-cable connector labeled MASSAGE into the control module connector also labeled MASSAGE (see picture of control module at top of previous page) until its locking tab snaps into place.

12.Insert the seat cushion cable connector labeled HEAT A into the back cushion cable connector also labeled HEAT A until its locking tabs snap into place, as shown at right.

Connect Upper

and Lower Cables

Connect HEAT A

Cables

13.Insert the cable connector labeled HEAT into the control module

connector also labeled HEAT (see picture of control module at top of previous page) until its locking tab snaps into place.

14.Place the cable labeled HEAT A inside the junction box. Replace the junction box cover; replace the two hex head screws that secure the junction box cover (see picture of junction box at top of previous page). Use a 1/4" hex wrench to secure the screws.

15.Gather loose cable sections and secure them with the plastic cable ties furnished (see picture of junction box at top of previous page).

16.With assistance, carefully return the recliner to its upright position.

17.Reinstall the left side table with the ball lock pin.

18.The Heat and Massage Unit is now ready for operation. Instructions for use follow.

s. NOTICE:.Before.rolling.the.recliner,.ensure.the.power.cord.is.unplugged.from.the.AC. outlet.

Heat and Massage Unit Operation Instructions

1.Plug the power supply cord into any grounded outlet.

2.The Heat and Massage Unit is operated using the single multi-position selector switch located on the right side of the recliner underneath the armrest. The Heat and Massage Functions can be operated independently. The selector switch faceplate is shown at right.

3.Press the selector switch UP to activate the HEAT FUNCTION.

4.Press the selector switch DOWN to activate the MASSAGE FUNCTION.

FR587W-INS-LAB-RevC13: Deluxe Extra-Wide Clinical Care Recliner Assembly and Operating Instructions

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Save this Manual for Future USE Contents Introduction Important Safety PRECAUTIONS-PLEASE Read Before USEIntended USE Distributed Assembly Upholstered Back AssemblyUnpacking Product DescriptionBack as shown at right Place Clevis Pins Place Cotter Pins Operation Tente CastersSide Table Operation To lower table Lift the side table up slightly until tabsSide Panel Operation Recliner Operation First Position Upright PositionSecond Position First Recline Position Third Position Second Recline PositionTrendelenburg Position Also Known as Shock Position Back Angle AdjustmentTrendelenburg Position can be obtained from any position GAS Spring Troubleshooting Guide Adjusting Cable TensionLumex Clinical Care Recliners with Heat and Massage Feature Installation and Operating GuideDescription ConnectionHeat and Massage Unit Setup Instructions Heat and Massage Unit Operation Instructions Heat and Massage Unit Troubleshooting Guide POST-INSPECTION Upholstery Maintenance and Stain Removal Care and MaintenanceEvery Three Months Page Page Technical Specifications Limited Warranty
Top Page Image Contents