SPECIFICATIONS
SPECIFICATIONS
Voltage | 36 V DC |
Number of Brazes (Per Charge) | 50 |
Weight (incl. Battery) | 9.8 kg / 21.6 lb |
Width | 5.9 inch / 150 mm |
Height | 11.0 inch / 280 mm |
Length | 12.5 inch / 320 mm |
Temperature Range |
EPX10 | Econect Battery Kit (For Units S/N 1215091 and Up) | 73077 |
EPX10 | Econect Battery Kit (For Units S/N 1215090 and Below) | 73720 |
MAINTENANCE
EQUIPMENT
-Always make sure the batteries are fully charged.
-Check the cables from time to time for damage.
-Check the contact surface on the ground magnet from time to time to ensure a good connection.
-Make sure that the brazing pin with the ferule passes easily in the gun, centered.
BRAZING PINS AND FERRULES
RAILBONDS AND CABLE LUGS
SETTING RIGHT LIFT HEIGHT
The S15 brazing gun self adjust to the same lift height every time.
See separate instructions in the maintenance section if adjustment for the gun is necessary.
PIN HOLDERS
Squeeze the fingers on the pin holder together each time you feel that the brazing pin goes in too easy when mounting them into the pin holder. This is important since all the current goes thru the pin holder to the brazing pin. If the fingers are too loose the pin holder will be damaged and must be replaced.
10 ► EPX10 User Manual