Stanley Black & Decker EPX10 user manual Replacing the Battery

Page 23

REPLACING THE BATTERY

The Battery kit (P/N-73720) and steps 1 thru 19 listed below applies only

to units with S/N 1215091 and Higher. For Units with serial number 1215090 & below, these units must be returned to the factory for battery replacement.

Econect battery kit P/N-73720 for serial number 1215091 and Higher.

Including: Econect battery.

2 x 13mm spanner. 3mm hexagon key. Side cutters.

Resistor 22Ohm/4W. 2 x Plastic washer.

3 x Cable ties.

1.Remove all screws on the sides of the unit with a 3mm hexagon key.

2. Cut the cable ties for the positive and fan cable.

3. Pull out the connector for the fan.

EPX10 User Manual ◄ 23

Image 23

Contents EPX10 Weisbeck, Andy Declaration of ConformityTable of Contents Local Safety Regulations Safety SymbolsSafety Precautions LED Charging the BatteryPreoperation Initial Setup and Battery ChargingOperation On / OFF PIN BrazePIN Holders SpecificationsSetting Right Lift Height EquipmentLifting Height Control MaintenanceBattery Indicator Periodic maintenance of S15 automatic gun Lift level tool Advanced maintenance work Adjusting the liftlevel Brazing Never Stops TroubleshootingNothing Happens When YOU Press Buttons PIN & Ring Holders AccessoriesBrazing Pins & Ceramic Rings Standard Brazing Pins Ceramic RingsType D ConnectorsType C Grinder Grinder AbrasivesGuns Cables EPX10 Parts Illustration Higher only EPX10 Parts ListFuse 5AT EPX10 Electrical DiagramReplacing the Battery Replacing the Battery Replacing the Battery Replacing the Battery Replacing the Battery