Fisher-Price L0542 manual Assembly

Page 4

Assembly

IMPORTANT! Before assembly and each use, inspect this prod- uct for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed.

Never substitute parts.

Footrest

Seat Bottom

1

Place the seat bottom face down on a flat surface.

At an angle, fit the footrest on the seat bottom, as shown.

Plastic Rings

Seat Bottom Tubes

2

Plastic Rings

 

Slide a seat bottom tube through each set of plastic rings on the seat bottom.

3

Align the holes in the plastic rings and the seat bottom tubes.

Insert a #8 x 1,9 cm screw through each plastic ring and into the seat bottom tubes, as shown. Tighten the screws. This may require extra force.

Push the seat bottom tubes back and forth to be sure they are secured to the seat bottom. If the seat bottom tubes move, you have probably not fastened them properly. Remove the screws and check to be sure the screw holes in the seat bottom tubes and seat bottom plastic rings are aligned. Replace and tighten the screws.

4

Image 4
Contents L0542 Consumer Information Prevent serious injury or death from falls or sliding outAssembled Parts Assembly Insert Screws Here Hinge Hinge Rod Hints Push Press Press Shoulder Straps Up Clips Lowest Slot Crotch Strap Down Smaller Baby Larger BabySecure Child To loosen the waist straps ABCNoteTo change strap slots Using the Trays Using the Teether Toy To adjust the seat height Adjusting the SeatTo adjust the seat angle Storage To remove the pad