Kawasaki B9272 owner manual Flat Side

		Assembly
12	Front Axle	Front Wheel	14	Right Grip	Left Grip
	Bushing	(Flat Side
	(Ring End	First)		Large Hole	Small Hole
	First)
	Washer
		Hubcap
		(Indented
		Side Out)
			• Turn the vehicle upright.
• Slide a washer onto a front axle.			Note: The left and right grips are not interchangeable!
			The hole in the left grip is smaller than the hole in
• Slide a bushing, ring end first, onto the front axle.
			the right grip.

• Slide a front wheel, flat side first, onto the front axle.			• Fit the left grip on the end of the left handlebar.
• Slide a hubcap, indented side out, onto the front axle.			• Fit the right grip on the end of the right handlebar.
			Hint: If it is difficult to slide the grip onto the handlebar,
			moisten the inside of the grip with water.
		Cap Nut
	13
		Cap Nut
		Assembly		15
		Tool

Seat

1

2

	.437"
		• Fit the tab at the front of the seat into the slot in the
		vehicle near the handlebars.
• Fit a cap nut on the end of the front axle.
		• “Snap” the tab at the back of the seat into the slot near
• Fit the cap nut assembly tool over the cap nut. Tap the
		the rear of the vehicle.
end of the cap nut assembly tool with a hammer to
secure the cap nut on the end of the axle. Pull on the
front wheel to be sure it is secure.

•Repeat steps 11 and 12 to assemble a washer, bushing, front wheel, hubcap and cap nut to the other front axle.

10