Battery Installation

IMPORTANT! Use only a Power Wheels® 12 volt battery with built-in thermal fuse. Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels®

12 volt charger before operating your vehicle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. Never charge the battery longer than

30 hours. Failure to follow these instructions may damage your battery and will void your warranty.

Seat

•Press the tab under the back edge of the seat and lift to remove the seat.

Motor

Harness Battery

Connector Clamp

Battery

•Lift the battery clamp to access the battery compartment.

•Place the battery upright in the battery compartment.

•Plug the motor harness connector into the battery. Push firmly to join.

3 Battery

Clamp

•Lift the battery clamp and slowly lower the battery into the compartment.

•Fit the tab at the front of the seat into the slot in the vehicle near the handlebars.

•“Snap” the tab at the back of the seat into the slot in the rear of the vehicle.