Assembly
Hooked End
8of the Steering Column
Steering
Linkage 
10
•Insert the #8 x 3/4” screw through the hole in the end of the steering column, so that the screw head faces the front of the vehicle.
•Slide the other steering linkage over the hooked end of the steering column and the other steering linkage.
•Fit the hooked end of the steering column into the hole in the steering linkage.
•Fit the #8 lock nut onto the end of the screw. Make sure the rounded side of the lock nut faces the rear of the vehicle.
•While holding the lock nut steady with an adjustable wrench, tighten the screw with a Phillips screwdriver. Do not
9
Washer
11
Steering
Linkage
Assembly
• Slide a washer onto the end of the steering column.
• Squeeze both steering linkages together.
• Insert four #10 x 3/4" screws into the steering linkage assembly. Tighten the screws with a Phillips screwdriver. Do not
9