Hub |
Clutch |
Spring |
Shouldered |
Bolt |
Figure 11. Assembly break down.
Figure 11A. Secure collar onto hand lever.
Hand Lever
Position depth stop to touch table and secure with lock knob before attaching hand lever. The head may drop sud- denly causing injury.
Attaching the hand lever requires the use of the 4 and 5mm Allen® wrenches supplied.
1.Locate the shouldered bolt, clutch and small spring.
2.Insert the spring into the clutch and place the clutch on the hub.
3.Secure the spring and clutch using the shouldered bolt. Insert the bolt and tight- en. Refer to Figure 11 for the layout of the parts.
4.Loosen the setscrew securing the collar closest to the end of the hand lever and remove the collar.
5.Insert the end of the hand lever into the smaller slot in the clutch. Slide the collar back onto the end of the hand lever and secure by tightening the setscrew. The lower collar should be set below the clutch by 1" to allow working clearances when the lever is swung out for indexing.
The hand lever can be adjusted for height by moving both of the collars up or down. Adjust these collars to accommodate the most com- fortable height for operation.
ASSEMBLY