Problem | Possible Cause | Solution | |
|
|
| |
The picture is in | Camera is on automatic night | If it should not be on night vision, | |
black and white. | vision due to low light conditions. | make sure that the light sensor on | |
|
| the camera is not being blocked. | |
|
|
| |
The sound on the | The volume is too low. | Increase volume level. | |
receiver is weak. |
|
| |
The units are too far apart. | Bring units closer together. | ||
| |||
|
|
| |
| Batteries are low or improperly | Check or replace batteries. | |
| installed. |
| |
|
|
| |
| AC adapters are not connected or | Check connections or change | |
| electrical outlet is out of order. | to another electrical outlet. | |
|
|
| |
There is static, distortion, | There may be be interference | Change the channel on both units. | |
interference, etc. | from other electrical equipment. |
| |
|
|
| |
| The receiver is out of range from | Bring units closer together. | |
| the camera. |
| |
|
|
| |
| Units are on different channels. | Make sure both units are on the | |
|
| same channel. | |
|
|
| |
There is feedback | The camera and receiver are too | Move them farther apart. | |
(squealing noises). | close to each other. |
| |
| Volume is too high. | Decrease volume level on receiver. | |
|
|
|
11