3M 7685-S-8 manual Remove semi-conductive jacket to dimension shown in Figure

12.4Remove constant force spring. Carefully bend shield wires back upon cable jacket 1 1/2" (38 mm). Cut excess shield wire and discard (Figure 17).

	Depth Of Terminal Lug + Growth Allowance
	[A] + 3” (76 mm)
1 1/2	(38 mm)
	Semi-Conductive Jacket
	Fold Back Shield Wires

Figure 17

12.5 Remove semi-conductive jacket to dimension shown in Figure 18.

NOTE: To ease jacket removal, install constant force spring as shown in Figure 18 and ring cut 80% through jacket. Remove jacket sections by pulling against constant force spring. DO NOT BELL SEMI-CON JACKET. Remove constant force spring.

NOTE: It is imperative to remove all remnants of the semi-conductive jacket, even if the semi-conductive jacket comes off as one layer. There should not be any remaining black areas, or particles, on the cable insulation layer.

		Depth Of Terminal Lug + Growth Allowance
			[A]
1 1/2	(38 mm)	1 1/2	(38 mm)
			Semi-Conductive Jacket
		Cut Line
		Constant Force Spring
		Fold Back Shield Wires

Figure 18

14 78-8119-6018-2 Rev C