OPERATIONS
USING PILEJOGGER II WITH
EXTRACTOR
1.Connect vacuum and solution hoses to
PILEJOGGER.
2.Plug power cord into properly grounded outlet.
3.Move PILEJOGGER to starting place. Turn on brush drive motor by depressing foot switch located on top of cleaning head. Depress solution valve lever fully and move backward at a steady pace (25 to 30 feet per minute).
NOTE: Lift the handle slightly as you move backward so the weight is almost off the rear roller. This will bring the vacuum orifice and brush into proper contact with carpet.
4.Release solution valve lever approximately 6 inches before reaching the end of the cleaning pass to ensure that all solution is extracted.
5.Make the next cleaning pass beside the first, overlapping about 1 inch.
6.Reverse direction and clean balance of room.
CAUTION: To prevent possible damage to the carpet, never let the PILEJOGGER stand in one place with the brush running.
86037500 PJ2A 03/04/08 |