Stow MS20E, MSD0H operation manual Electric Motor Connection, Electric MotorVoltage Switch

MS20H/MS20E MIXER — ELECTRIC MOTOR

Electric Motor

For maintenance care and operation of the electric motor, refer to your electric motor instruction booklet furnished with the motor.

Protect the electric motor from dust as much as possible and keep ventilating openings clean.

CAUTION:

■DO NOT spray water at any time on the electric motor.

■DO NOT operate electric motor in a explosive environment.

The electric motor used in this mixer is a single-phase 1.5 HP motor. The input voltage requirement for this motor is either 115 or 230 VAC only.

Electric Motor Connection

A 12 inch electrical cable (Figure 2) with a pigtail at one end is provided with the electrical motor for hookup to a power source. Table 1. shows the required NEMA connector for the desired motor horsepower rating. In addition, Table 2 also shows the matching NEMA approved connector for the required extension cord.

ALWAYS, make certain that the power source required for the electric motor is correct and always use the correct NEMA configuration plug. Failure to supply the correct voltage to the motor can severely damage the motor.

The motor supplied is wired for 115 VAC grounded operation. Make certain that the correct size grounded (3-wires) extension cord is used. See Table 4.

Motors can burn out when the line voltage falls 10% below the voltage rating of the motor. Failure to use proper voltage will cause the motor to overheat and actuate the overload switch.

If overload protection should actuate because of improper voltage or any other malfunction, turn the main switch on the motor to the "OFF" position and correct the problem, press the reset switch button, and turn the main switch to the "ON" position.

It is strongly recommended that all electrical wiring be done by a licensed

NOTE electrician. Special attention should be given to the electric switch as well as the over-and-under voltage protection devices as per regulations

set forth in the local electrical safety code handbook.

Electric MotorVoltage Switch

1.ALWAYS make certain the motor switch is "OFF" and the power cord has been disconnected from the power source.

2.Remove the voltage lock-out bolt (Figure 3). Change the position of the voltage change toggle switch from 115 VAC to 230 VAC. The mixer is factory wired for 115 VAC operation.

3.Replace the voltage lock-out bolt.

4.Important!, when changing the input voltage to the motor from 115 to 230 VAC the plug on the motor power cord must also be changed. See Table 3.

Table 3. Electric Motor Wiring Information

Motor	115-230 VAC - Single Phase
Horsepower
	NEMA Plug Connector	Mating NEMA
Rating
		Receptacle Connector
1.5 HP	L5-20P P/N EM940537	L5-20R P/N EM940538
(115 VAC)
1.5 HP	L6-20P P/N 940539	L6-20R P/N 940540
(230 VAC)

Table 4. Recommended Extension Cord Sizes

Model	Motor	Voltage	50 ft.	75 ft.	100 ft.	200 ft.
			(15.24 m)	(22.86 m)	(30.48 m)	(60.96 m)
MS20E	1.5 HP	115	No. 12	No. 10	No. 8	No. 6
(Electric)
		230	No. 14	No. 12	No. 12	No. 8

MQ STOW MS20H/MS20E MIXER — PARTS & OPERATION MANUAL — REV. #3 (08/10/06) — PAGE 15