MS20H/MS20E MIXER — INITIAL START-UP
4.Turn the engine switch (Figure 15) to the ON position.
Figure 15. Engine ON/OFF Switch
5.Located on the engine cover is the main start/stop switch (Figure 16). Pull this switch outward to start the engine.
CAUTION:
Make certain the drum lock pin (Figures 18 and 19) is placed to the right (when viewing the mixer from the towpole end) of the drum stop block which is welded to the front side of the drum. Also make sure lock pin is fully engaged (locked). This will prevent the drum
from tipping.
Figure 19. Drum Lock Pin (Side-View)
Figure 16. Start/Stop Switch (gasoline)
6.Place the belt slip lever (Figure 17) in the START/STOP position.
Figure 19. Drum Lock Pin (Right Position)
7.Pull the starter grip (Figure 20) lightly until you feel resistance, then pull briskly. Return the starter grip gently.
Figure 18. Belt Slip Lever |
|
(Start/Stop Position) | Figure 20. Starter Grip |
PAGE 26 — MQ STOW MS20H/MS20E MIXER — PARTS & OPERATION MANUAL — REV. #3 (08/10/06)