Oricom SECURE 200 manual Power requirements

Page 3

WARNINGS AND SAFETY INFORMATION 1

IMPORTANT

Please read this user guide thoroughly before use.

Your ORICOM Baby Monitor is designed to be an aid and should not be used as a substitute for responsible and proper adult supervision of a child.

The Baby Monitor has been designed to provide some added reassurance in the form of sound transmission for those times when you are not in the same room as your baby provided you always stay within hearing range of the baby monitor during use. Your Baby Monitor is not a medical device, nor a device to prevent cases of Sudden Infant Death Syndrome (SID'S) or "cot death", and you should not rely on it for your baby's wellbeing. It is important that you regularly check on your baby personally.

Make sure the Baby unit, Parent unit and mains adaptor cables are kept out of reach of your baby and other young children within the house at all times, at least one metre away from the baby’s cot.

Never place the baby unit inside your baby’s cot, bed or playpen.

Never cover the Parent or baby units with clothes, towels or blankets or any other item.

Do not place the cord in a high "wear and tear" location. Never use a frayed or compromised cord.

Never use or place your Parent or Baby units in or near moisture or water (e.g. near bath or pool). Immersing in water can cause electric shock and even death.

Power requirements

In Australia this product requires an electrical supply of 220-240 volts, single phase/alternating current.

CAUTION

!Use only the mains power adaptors supplied with this equipment. Incorrect adaptor polarity or voltage can seriously damage the unit and/or cause physical harm and even death. The adaptors may become warm during use, please take care when handling.

AC Adaptor (Baby unit)

AC Adaptor (Parent unit)

Input: 100-240VAC50/60Hz

Input: 100-240VAC50/60Hz

Output: 6VDC 500mA

Output: 7VDC 420mA

If you plan to use your Baby monitor whilst travelling overseas, make sure that the voltage shown on the mains power adaptor is the same as the local mains power before connecting to the power supply. Do not use any voltage converter with the monitor.

Image 3
Contents Baby Monitor Table of Contents Power requirements Cleaning and care Installation Pack ContentsGetting Started For the Baby Unit Baby unit Sender Your Baby MonitorLeft view of baby unit Parent unit Receiver Charger Pod Baby Unit Parent Unit LCD Display of Baby MonitorMonitoring Power On/OffAdjusting Volume Basic OperationLullaby Baby alertPaging Night lightTemperature ClockTime for a Feed Torch Low BatteryTalk to your Baby Out of RangeCharging the Battery Sensitivity Setting Menu SettingsNight light Setting Lullaby SettingSet On or Off Sound Alert SettingTemperature Setting Adjust VolumeSet temperature alert volume Clock SettingSet desired baby room temperature range Set temperature alertFeed Time Setting Set the timeSet the hour format Set the first or next feed time Language SettingSet Alarm on or off Set Alarm VolumeProblem Possible causes TroubleshootingFeature Specifications Product SpecificationsWarranty Information Australia GuaranteeCustomer Support