Fisher-Price B8865 manual Position the seat back tube so that it bends backward

Page 8

Assembly

Seat Back

Tube Bends

Backward

Retainers

Base

Wire

Base

Wire

3

•Position the seat back tube so that it bends backward.

•Fit the seat back tube completely onto the base wires. Make sure the hole in each end of the seat back tube aligns with the hole in each base wire.

•Fit a retainer (rounded side inward) to one end of the seat back tube.

•Insert a screw through the outside hole in the seat back tube and into the retainer.

•While holding the retainer in place, tighten the screw with a Phillips screw- driver. Do not over-tighten.

•Repeat this procedure to secure the other side of the seat back tube to the base assembly using the remaining retainer and screw.

8

Image 8

Contents Kick & Play Consumer Information To prevent serious injury or deathShown Actual Size Parts#8 x 2 cm 3/ 4 Screw Toy Bar Battery InstallationSoothing Unit Battery Safety Information Assembly Back ViewAssembly Position the seat back tube so that it bends backward Pull Up Pad Footrest Seat Back Tube Restraint Belts Assembly is now complete Make sure you hear a click on both sides Set-Up &UseSecuring Your Child Calming Vibrations To tighten the beltsTo loosen the belts Parent Activated OffTo re-assemble the pad CareTo remove the pad