D Battery Installation
The receiver operates either with the AC adaptor
included with your Sound ’n Lights Monitor
or with a 9 volt alkaline battery.
9V
(LR6)
Shown Actual Size
Battery Compartment Door
Finger
Tab
•Locate the battery compartment door on the bottom of the receiver.
•Push the finger tab on the battery compartment door to open the battery compartment door.
•Snap the terminals of a fresh 9v alkaline battery into the connectors.
•Close the battery compartment.
Please Note:
•Remove the battery during long periods of
•Never short circuit the battery terminals.
•A
•Only a battery of the same or equivalent type as recommended in the “Battery Installation” instructions is to be used.
•If a removeable rechargeable battery is used, it is only to be charged under adult supervision.
•A rechargeable battery is to be removed from the product before it is charged.
•If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure and other parts. Do not use a damaged battery charger until it has been properly repaired.
E Set-Up and Use
IMPORTANT NOTE! To prevent entanglement, never place the transmitter in a crib or playpen. Place the transmitter, receiver and AC adaptor cord(s) out of baby’s reach.
Antenna
On/Off Switch
Channel Switch |
|
|
|
|
AC Adaptor Jack |
|
|
| Power |
OFF | ON | POWER | Indicator | |
| A | B | CHANNEL |
|
|
|
|
| |
|
|
|
| |
|
|
|
| Fisher |
Socket
Plug
AC Adaptor
Transmitter
•Place the transmitter in the same room with your child. For best sound
•For best transmission, unwrap and fully extend the AC adaptor cord. Insert the AC adaptor jack into the transmitter socket.
•Insert the plug into a standard wall outlet.
•Set the transmitter channel switch to the same channel as the receiver.
•Slide the on/off switch on the front of the transmitter to
the “ON” position.The power indicator will light.
4