9.Position the blower motor inside the canopy so that the mounting tabs are aligned with the large end of the keyhole slots on the back panel. Push down to lock the blower motor in place and align the holes for the mounting screws. Install mounting screws and tighten.
A
B
A. Mounting tab
B. Blower motor mounting screws
10.Reconnect the blower wiring plug.
A
B
A. Blower wiring plug
B.Blower
11.Reattach center glass cover to canopy. Tighten screws.
12.Reinstall metal filter. See the “Range Hood Care” section.
13.Close center glass cover.
14.Using 2 or more people, set range hood onto its bottom on a covered surface.
15.Install the 3¼" x 10" (8.3 x 25.4 cm) damper (supplied) to the back of the canopy using 3 of the the screws removed from the 8" (20.3 cm) diameter transition damper. Tighten screws.
A
A. Damper mounting screws
Install Range Hood
NOTE: For rear venting installations, the 3¼" x 10"
(8.3 x 25.4 cm) damper must be assembled to the back of the hood before installing the range hood. See the “Connect Vent System - For Rear Venting Installations Only” section for instructions.
1.Using 2 or more people, hang range hood on 2 mounting screws through the mounting slots on back of hood.
A
B
C
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2.Remove the grease filter. See “Range Hood Care” section.
3.Level the range hood and tighten upper mounting screws.
4.Install 2 - 5 x 45 mm lower mounting screws and tighten.
9
