Jenn-Air W10274314C Range Hood Use, Install Vent Covers, Complete Installation, C D A B

Install Vent Covers

NOTE: This hood can be installed without the chimney covers when venting directly out the back or when using the recirculation kit with the top grille cap. See the “For non-vented (recirculating) installations without vent only:” section

When using both upper and lower vent covers, push lower cover down onto hood and lift upper cover to ceiling and install with two 4 x 8 mm screws.

NOTE: For vented installations the upper vent cover may be reversed to hide slots.

C

D A

B

A. Upper vent cover

B. Lower vent cover

C. 4 x 8 mm screws

D. Bracket

Secure the bottom of the duct with 2 - 4 x 8 mm screws.

Complete Installation

1.For non-vented (recirculating) installations only, install charcoal filters over grille on blower housing. See the “Range Hood Care” section.

2.Install metal filters. See the “Range Hood Care” section.

3.Check the operation of the range hood blower and light. See the “Range Hood Use” section.

NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.

The range hood controls are located at the bottom right hand side of the canopy.

A

B

	C
	D
	E
	F
G
A. Louver holes (non-vented	D. Control panel
[recirculating] installations only)	E. Grease filter
B. Duct covers	F. Grease filter release handle
C. Canopy	G. Lamp housings
Range Hood Controls
Light
On/Off	A
Fan
Off	B
1
	C
2
	D
3
	E

A. Light on/off

B. Fan off

C. Fan speed minimum button

D. Fan speed medium button

E. Fan speed maximum button

Operating the light

The Light On/Off button controls both lights. Press once for On and again for Off.

12