Bebe Sounds Be005 instruction manual Instructions for Listening to Your Unborn Baby

INSTRUCTIONS FOR LISTENING TO YOUR UNBORN BABY

(See Figs. 10 and 11)

1.Remove the battery cover and install a new 9-volt battery (not included). We recommend using a new battery as an old one will severely interfere with the performance of your Prenatal Heart Listener®. Be sure to match positive (+) to positive (+) and negative (-) to negative (-). Replace the battery cover.

2.Insert the headset plug into either jack on the unit and put the headset on. For two people to listen at the same time, insert the second headset plug into the other jack.

3.Be sure the foam cover is in place on the listening cone. Hold the listening cone to your stomach or lower back. Use the Prenatal Listener® on bare skin in a quiet room.

4.Turn the Prenatal Heart Listener® on by turning the Power/Volume control wheel to the right until you hear a click. The red power indicator on the front will light up to indicate the unit is in the ON position.

5.Adjust the volume to optimize the listening level and amplification. Begin with a low to moderate level to avoid static.

6.Start by placing the listening cone two inches below and several inches to the right of your belly button. Gently move the unit one inch at a time to different places until you find the best position for listening to your baby's sounds. Before moving the Prenatal Listener®, turn the volume level down to the lowest position to avoid the sound of the cone moving against your skin.

7.When you are finished, turn the Power/Volume control wheel all the way to the left until you hear a click to turn the Prenatal Listener® off. The red power indicator light will turn off.

9