Basic Base Functions
Basic Base Functions
Foot Prop
To use foot prop, press release button and compress foot prop, then swing foot prop up from base, into Installation Mode (fig. A).
WARNING:
•Always use foot prop when base is installed in vehicle! Foot prop must be in Installation Mode for proper carrier attachment to base.
•Never use foot prop to raise base above vehicle seat surface. Doing so will reduce the stability of the base.
Adjust foot prop height by pressing Foot Prop Adjust Button while sliding foot prop to the shortest position that provides contact with the vehicle floor (fig. B).
A
Using Carrier with Base
To attach, line up carrier with base, rear facing, then push down until positive click confirms correct attachment (fig. D). Check installation by lifting carrier from both ends to verify that both attachment rods are engaged with the base. Visual confirmation can be made, using the button indicator on the rear of the base (fig. E).
WARNING: Carrier must be attached properly to the base. When carrier is attached properly, the green indicator band on the release button is fully visible (fig. E).
To release, press release button on base, then lift carrier to remove (fig. F).
D
To store foot prop for transport outside of the vehicle, adjust to shortest position, then collapse into Storage Mode (fig. C). Press tab into slot on bottom of base to secure.
B
1
2
IMPORTANT: Always adjust handle to In- Vehicle position while using in a vehicle.
E
IndicatorIndicator
C
E
20 | 21 |