4. Operating Instructions
Operating Modes
•A
•Master/Slave output provides for unison triggering of chained strobes.
•
Stand Alone
The Stand Alone mode is activated automatically when the fixture is absent of a | ||
or a DMX controller. Note! All dipswitches |
|
|
must be set to the OFF position. The |
|
|
strobe speed and strobe intensity can be |
|
|
adjusted and they are located on the side |
|
|
of the fixture. The strobe will continue to |
|
|
operate at the user set levels until it is | SPEED | DIM |
turned off. Upon turning the strobe back on |
|
|
the unit will continue in the previously set levels. |
|
|
Unison Strobe (Master/Slave)
The Unison strobe mode will allow you to link additional units in a daisy chain fashion. Simply, connect each fixture in a daisy like fashion using certified DMX XLR cable. Be sure that all DMX dipswitches are set to the OFF position.
SPEED DIM
DMX Out
DMX In
DMX Control Mode
In this mode the user can control the strobe light remotely. Both the intensity and the flash rate can be programmed as part of a scene or a cue. To blackout the unit entirely it requires both intensity and flash rate to be at 0 levels.
1.Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the controller.
2.Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input connector of the next fixture consisting of a (male) 3 pin connector.
3.Then, proceed to connect from the DMX output as stated above to the DMX input of the following fixture and so on.
4.If you need help setting the DMX address read the section titled “Setting the DMX address” in this Chapter.
11 |