FOLDING and STORING continued
6 Fold bassinet.
7 Place bassinet in pocket of travel bag.
IMPORTANT: If continuing to use Playard, be sure to properly secure floorboard in Playard.
Playard
1 To remove floorboard:
• Unfasten attachment straps.
• Remove floorboard and set aside.
2 Lift Floor Handle, rotate counterclockwise to unlock floor and pull up, approximately 45.7 cm (18 inches).
4Gather Playard frame together while pulling up on Floor Loop.
5Wrap floorboard around Playard
frame with padding facing in.
NOTE: Floorboard Handle MUST be aligned with wheels as shown.
6Secure Attachment Straps by threading through loops
on end of floorboard and folding back onto itself.
NOTE: Make sure floorboard is positioned above wheels.
Attachment
Straps
Floor Loop
Handle
Floor
Handle
3To fold top rails:
•Pull up on top rail slightly.
•Squeeze Release Button on bottom of top rail and push rail down. (Release buttons are identified by printed arrows.)
Repeat for other sides.
NOTE:
•If rails are difficult to unlock, raise center of floor higher and squeeze Release
Button again.
• If only one side of rail |
folds, squeeze Release |
Button again to fully |
Release Button
7Position travel bag over Playard
so Handle comes through Opening in side of bag.
Pull travel bag over Playard.
Pull Floor Loop through opening on top of travel bag.
NOTE: To prevent rubbing, make sure travel bag is positioned above wheels.
Floor Loop
Opening
Handle
fold. |
8