Lenovo 5067, 384, 4168, 7516, 7519, 5027, 266, 2491 manual Diagnostic Error Code FRU/Action

Diagnostic Error Code	FRU/Action
086-199-XXXMouse Port interface test failed, cause	1. See “Undetermined problems” on page 66.
unknown	2.	Flash the system and re-test. See “Updating
		(flashing) the BIOS from a disc” on page 180.
	3.	Replace component under function test.
089-000-XXXMicroprocessor Test Passed	No action
089-XXX-XXXMicroprocessor failure	1. Microprocessor(s)
	2.	System board
089-195-XXXMicroprocessor Test aborted by user	Information only Restart the test, if necessary.
089-196-XXXMicroprocessor test halt, error threshold	1.	Press F3 to review the log file.
exceeded	2.	Restart the test to reset the log file.
089-197-XXXMicroprocessor test warning	1. Make sure the component that is called out is
		connected and/or enabled. See Chapter 6 “Using the
		Setup Utility program” on page 41.
	2.	Re-run the test.
	3.	Replace the component that is called out in warning
		statement.
	4.	Replace the component under test.
089-198-XXXMicroprocessor test aborted	1. Flash the system. See “Updating (flashing) the BIOS
		from a disc” on page 180.
	2.	Go to “Undetermined problems” on page 66.
089-199-XXXMicroprocessor test failed, cause unknown	1. See “Undetermined problems” on page 66.
	2.	Flash the system and re-test. See “Updating
		(flashing) the BIOS from a disc” on page 180.
	3.	Replace component under function test.
170-000-XXXVoltage Sensor(s) Test Passed	No action
170-0XX-XXXVoltage Sensor(s) failure	1. Flash system
	2.	System board
170-195-XXXVoltage Sensor(s) Test aborted by user	Information only Restart the test, if necessary.
170-196-XXXVoltage Sensor(s) test halt, error threshold	1.	Press F3 to review the log file.
exceeded	2.	Restart the test to reset the log file.
170-197-XXXVoltage Sensor(s) test warning	1. Make sure the component that is called out is
		connected and/or enabled. See Chapter 6 “Using the
		Setup Utility program” on page 41.
	2.	Re-run the test.
	3.	Replace the component that is called out in warning
		statement.
	4.	Replace the component under test.
170-198-XXXVoltage Sensor(s) test aborted	1. If a component is called out, make sure it is
		connected and/or enabled. See Chapter 6 “Using the
		Setup Utility program” on page 41.
	2.	Flash the system and re-test. See “Updating
		(flashing) the BIOS from a disc” on page 180.
	3.	Go to “Undetermined problems” on page 66.

60ThinkCentre Hardware Maintenance Manual