18 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| V I | I | . |
| O | p | e | r | a | t | i | n | g |
| I | n | s t r | u | c | t | i | o | n | s |
| |||
| D. TRANSIT USE |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||||
| 5 |
|
|
| |||||||||||||||||||||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||||||||||||||||||||||||||||
1.If possible and feasible, the rider should transfer to the vehicle seat and use the vehicle restraints.
2.If the mobility base is used for transport, it must be used with occupant facing forward in the
vehicle.
3.The occupant must not weigh more than 150 pounds.
4.The location of the securement points is shown. (See Figs. 5, 6)
5.Use only with WTORS that have been installed in
accordance with the manufacturer's instructions |
|
|
| 6 | |
and SAE J2249. |
| |
|
|
6.Attach WTORS to the securement points in accor- dance with the manufacture's instructions and SAE J2249.
7.Attach occupant restraints in accordance with the manufacturer's instructions and SAE J2249.
NOTE– To obtain a copy of SAE J2249 Wheelchair Tiedown and Occupant Restraint Systems for Use in Motor Vehicles, please contact: SAE International on the internet at www.sae.org/ or by phone at
E. TRANSIT OPTION INSTALLATION
Tools Required:
1.10mm socket & ratchet
2.4mm Allen wrench
3.Torque wrench
To Install the Front Transit Bracket (Figure 7)
1.Install (2) 10 mm x 38.5 mm flat head cap screws through the transit bracket and plastic saddles continuing screws through holes in frame on the right side of transport chair. Ensure the curved portion of the saddles contact the round tubing. Front transit brackets are mounted on the outside of the frame with both front transit brackets facing forwad.
2.Install flat washers and nylock nuts to secure screws. Hand tighten.
3.Repeat procedure for the left side of frame.
4.Ensure both front brackets are mounted to the outside of the frame and facing forward.
7
100336 Rev. D