Fisher-Price 79026 instruction sheet Care, To remove the pad

Page 12

 

Care

 

 

 

FCC

No

te

(U

nited

St

ates

Only)

 

 

The pad is machine washable. Wash the pad separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly.

The frame, toy bar and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not use bleach. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue.

To remove the pad:

Unfasten the buckles around each side rail.

Turn the seat face down on a flat surface. Unfasten the buckles on the pad.

Turn the seat upright. Remove the hardboard from the slot in the front edge of the pad.

Pull the front and back of the seat back area of the pad apart.

Lift the pad off the seat.

To replace the pad, refer to Assembly steps 8 and 9.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer- ence to radio or television reception, which can be deter- mined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Consult the dealer or an experienced radio/TV technician for help.

Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user‘s authority to operate the equipment.

 

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.

 

©2002 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.

Printed in China

79026pr-0920

Image 12
Contents Infant-to-ToddlerRocker Consumer Information Parts For other countries, outside the United StatesAssembly #8 x 3/4 Screw Shown Actual SizeInsert a #8 x 11/4 screw Tabs snap into place. Make sure you hear a snap on each side Assembly is now complete Tips Recline Make sure you hear a click on both sidesToys To tighten the beltsTo loosen the belts Toy Bar Calming VibrationsKickstand Storing the Restraint System for Toddler UseCare To remove the pad