English 13
Connecting the belt clip
1Insert the small pin on the back of the belt clip into the opening on the back of the parent unit (1).Turn the belt clip to the left (2) until it locks into position (‘click’) (Fig. 24).
Disconnecting the belt clip
1Turn the belt clip to the right (1) and take it out of the opening (2) (Fig. 25).
Connecting the neck strap
1Insert the small pin at the end of the neck strap into the opening on the back of the parent unit (1).Turn the neck strap to the left (2) until it locks into position (‘click’) (Fig. 26).
Disconnecting the neck strap
1Turn the neck strap to the right (1) and take it out of the opening (2) (Fig. 27).
Reset function
This function allows you to reset the baby monitor to the default settings.You can use this function if
problems occur that cannot be solved by following the suggestions in chapter ‘Frequently asked
questions’.You have to reset each unit separately.
1Press and hold the on/off button 3 for 2 seconds to turn on the unit. (Fig. 11)
2Then immediately press and hold the volume down
,The unit has now been reset to the default factory settings.
Now do the same for the other two units.
Default settings
Parent unit
-Loudspeaker volume: 1
-Microphone sensitivity: 3
Baby unit
-Loudspeaker volume: 3
-Nightlight: off
Cleaning and maintenance
Do not immerse the units in water and do not clean them under the tap.
Do not use a cleaning spray and/or liquid cleaners.
1Unplug the baby unit if it is connected to the wall outlet and take the parent unit out of the charger.
2Clean the units with a damp cloth.
Storage
,You can use the travel pouch to store the baby monitor while you travel.
,When you are not going to use the baby monitor for some time, remove the batteries and store the units and the adapters in the travel pouch supplied.
Environment
Disposal of your old product
Your product is designed and manufactured with
be recycled and reused.