!IMPORTANT NOTE
When using your stroller as an infant car seat carrier, the following are the compatible infant car seat models that the Big Caboose
• Baby Trend® | • Evenflo® Embrace™ |
• Britax® Companion™ | • Graco® Safe Seat™ |
• Chicco® Key Fit Car Seat | • Graco® Snug Rider™ Series |
• Combi® Centre Series | • Maxi Cosi Mico |
• Combi® Connection | • Peg Perego® Primo Viaggio |
• Compass® Light and Portable Infant | • Peg Perego® Primo Viaggio SIP |
Car Seat | • Safety 1st® Designer 22™ |
• Eddie Bauer® Infant Car Seat |
|
(models |
|
For the most updated list of compatible infant car seats, please either check our website
at www.joovy.com or call our Customer Service Department at (877)
Folding the Stroller
•Keep children away from stroller while folding.
•Remove any infant carrier that has been installed on the stroller. Note that the stroller can still be folded with the car seat carrier support in place.
•Position the stroller with the handle bar closest to you.
•Place the canopies into their closed position and push them all the way forward toward the front of the stroller as far as they will go.
•Make sure both rear wheel brakes are set to their locked positions.
•Lock both front wheels in place with the locking levers facing forward.
•To fold, unlatch BOTH safety latches on the lower left and right side of the stroller.
•Pull upward on the trigger mechanisms on both sides of the stroller. See Figure 28.
•While these mechanisms are in the upward position, push forward on the stroller using the handle bar.
•Once the stroller begins to fold, push the handle all the way forward and down until the stroller is completely folded. See Figure 29.
CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
•Secure the stroller in the folded position by engaging the locking latch on the right side of the stroller over the extended rivet. See Figure 30.
Figure 28 | Figure 29 |
Page 13 | The Big Caboose |