Securing a Child in Either Front Seat

•Ensure that the two snaps on both armrest pads that hold the seat onto the frame are securely snapped together.

•Ensure that both shoulder straps are attached to the waist strap buckles. See Figure 17.

•Unlatch the waist/shoulder buckle by squeezing the latch releases on both sides of the buckle and removing the male ends of each buckle.

•Carefully place the child in the stroller seat with the shoulder straps over their shoulders and chest. Then place the crotch strap between the child’s legs.

•NOTE that there are three height adjustment positions for the shoulder harness straps. For a younger child, the shoulder straps should be positioned through the lower sewn-in loops on the seatback. For a young child that is tall, the shoulder straps may be positioned through the upper sewn-in loops on the seatback. For a taller child, use the shoulder straps WITHOUT positioning them through these sewn-in loops. To re-position the shoulder straps, unbuckle them from the harness buckle and feed these straps through the sewn-in loops, insuring that they are not twisted. Re-buckle the shoulder straps onto the harness buckle to secure them.

•Bring the seat belt around the child’s waist and insert the male ends of the waist/shoulder buckle into the female buckle. Ensure that they snap into place. See Figure 18. Tighten the waist belt to be snug around the child’s waist.

•Both the shoulder straps and the waist/crotch straps may be adjusted using the sliding buckles on these straps. See Figures 19 and 20.

!WARNING

Avoid serious injury from falling or sliding out. Always use the seat belt and harness.

Figure 17

Figure 18

Figure 19

Figure 20

The Big Caboose Stand-On Triple Instruction Manual

Page 8