InStep RIDE N STRIDE Proper USE of Seat Belts, For Transportation or Storage of TRAILER/STROLLER

PROPER USE OF SEAT BELTS

WARNING: Avoid serious injury, always use seat belts.

Please Note: For the following instructions see Figure Y.

Step 1. To place child in seat, undo front and side Velcro, pull flap all the way up, and drape over rollbar.

Step 2. Place children in seat. Snap the lap belt together over the children’s lap. Please note that there is one lap belt for both children. Make sure belt is adjusted to fit snugly.

Step 3. Place set of shoulder harnesses over shoulder of each child and clip the hook end of shoulder harness by pulling the strap on harness. You can adjust the crotch strap length according to the size of the child. Make sure the connection of the crotch strap to the shoulder harness is located near the child’s stomach. You do not want the crotch strap too high on the child’s chest.

Step 4. When using with one child, you must place the child in the center of the seat. Attach lap strap across child. There is a crotch belt for the center position. Take the two shoulder harnesses in the center of the seat and clip into the center crotch strap. Make sure crotch strap comes up between child’s legs. Adjust belts for a snug fit.

Y

Shoulder

Harness

Lap Belt

Crotch

Strap

Step 5. When not in use, always hook crotch strap to shoulder harnesses so belts will not drag on ground. Adjust center crotch strap too.

Step 6. Be sure to securely fasten canopy over front end of trailer/stroller. Your trailer/stroller comes with a mesh front and rain shield. The mesh front must always be down to protect your child from objects that may fly up from your rear bicycle wheel. Protect your child in inclement weather by rolling rain shield down.

FOR TRANSPORTATION OR STORAGE OF TRAILER/STROLLER

Step 1.	Remove hitch from bicycle by turning	Step 4.	Fold trailer by removing locking pins
	knob counter clockwise. Unclip tow bar		from black latches. Unclip the black
	safety strap (Figure X).		latches and push the top of the
Step 2.			trailer/stroller to fold down completely
	Remove quick release tow bar pin. Flip		(Figures E and F).
	the tow bar 180 degrees so it is resting	Step 5.	Remove flag by sliding it from the
	underneath the trailer/stroller. Reattach
	quick release tow bar pin (Figures R		Two-in-One Canopy and Raincover. If
	thru W).		necessary, disassemble flag for storage.
Step 3.	Remove rear wheels. Remove locking	Step 6.	Be sure to keep this manual handy for
	pins from axle on the rear wheels		reassembly.
	(Figure O).

7