Baby Trend 7678T 7639T manual Triplet Stroller, Baby TREND, INC

Triplet Stroller 02.06

WARNING: Please follow all of these instructions to ensure the safety of your children. Keep these instructions for future reference.

WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out. Always use the safety belts and insure that the children are properly positioned according to these instructions.

WARNING: Never leave children unattended.

•Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause hazardous unstable conditions.

•The maximum weight that can be carried in the basket is 5 lbs and in the parent tray is 3 lbs. Excessive weight may cause a hazardous unstable condition to exist.

•Be certain the stroller is fully erect and latched in the open position before allowing the children near the stroller.

•Use of the stroller with three (3) children weighing more than 45 pounds each, or children totaling more than 135 pounds, will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to exist.

•DO NOT use the stroller on stairways or escalators.

•Never allow your stroller to be used as a toy

•To clean use only mild household soap or detergent and warm water on a sponge or clean cloth.

•Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed

•Discontinue use of stroller should it malfunction or become damaged. Please contact our customer service Parts Hotline to arrange for repair or obtain replacement parts.

Please: If you experience any difficulty with the use of our product or have a question regarding these instructions, please contact our Customer Service Department at (800) 328-7363 between the hours of 8:00 and 4:30 Pacific Coast Time. Please do not return the product to the store as once it is returned it cannot be re-sold and the materials and energy used to make it are wasted.

To contact us:
BABY TREND, INC.	Parts Hotline:
1567 S. Campus Ave.	(800) 328-7363
Ontario, CA 91761	8:00am to 4:30pm Pacific Coast Time

2

Rear Axle

Rear Canopy 2 Canopies Washers Clips Caps

Child Tray	Parent Tray	Front Wheels	Rear Wheels
Stroller

TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE
INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ASSEMBLY
1. Remove stroller from box. The front wheels, rear wheels, child
tray, parent tray and canopies need to be installed prior to use.
2. To attach the front wheels, unfold stroller as described in the		Figure 1.
section following. Lift front of stroller and snap each of the
front wheels onto the wheel casting steel bayonet. Ensure that
the wheels are firmly locked into place. Please see figure 1.
3. Assemble the rear wheels to the rear axle assembly as shown in
figure 2a. Slide washer onto axle. Slide wheel onto axle. Slide		Figure 2a.
the other washer onto axle. Secure wheel with the locking clip.
Snap wheel cap into place. Lean the stroller forward to rest on
the front wheels. To attach the rear wheels, position the rear axle
and wheel assembly such that the brake levers are facing to the
rear of the stroller. Press the rear wheel assembly onto the rear		Figure 2b.
frame tubes being careful that the push buttons on the forward
side of each rear tube engage the hole on the forward side of
each rear wheel housing. Pull on the rear wheel assembly to
ensure that it is securely attached to the stroller. Please see figue
2b.
Ensure that the wheels are firmly locked into place. Do Not use
the stroller if the wheels are not locked into place, but rather		Figure 3.
contact our customer service department immediately at (800)
328-7363, between the hours of 8:00am and 4:30pm PCT, for
assistance
4. Attach the canopies by inserting the male plastic fitting on the
bottom of the canopy into the female plastic fitting on either side
of the respective seat. See figure 3. The rear seat canopy has a
skirt that must be snapped to the rear seat seatback.
5. To attach the front tray, push the tray onto the front tubes of
the stroller frame until the tray locks into place. To remove	Figure 4.	Figure 4a.	3
the front tray, push the small metal ball located on each side