Assembly

IMPORTANT! To ensure safe operation of your stroller, please follow these instructions carefully. Please keep these instructions for future reference.

IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. NEVER use if any parts are mssing or broken.

IMPORTANT! Adult assembly is required.

FOOT REST

Push downward on the foot rest until it snaps onto the U-shaped frame cross member. (Fig. 4)

PARENT TRAY

To attach the parent tray, position the tray so that the hinges for the storage compartment are facing foward. Snap the parent tray to the stand at the top of the frame. Check that the tray is securely latched in place. (Fig. 5)

Push Down

Snap On

Fig. 4

red release

lever

Fig. 1

Fig. 2

Fig. 3

Remove stroller from box. The front wheels, rear wheels, child tray, and parent tray MUST be installed prior to use.

FRONT WHEELS

To attach the front wheels, unfold stroller as described in the section following:

•Unlock the red release lever.

•Unfold stroller frame by pulling backward on the stroller handle (Fig. 1)

To attach the front wheels, lean the stroller back so that it rests on the handle with the front and rear legs pointing upward. Position the front wheels over the front leg tubes so that the hole in the housing lines up and will slide onto the legs. (Fig. 2) Firmly push down until the wheels lock securely into place. Tug on each wheel to ensure they are both securely attached.

REAR WHEELS

Position rear axle over the rear leg tubes, brake pedals facing the back. At the same time, push down applying equal pressure to both sides until they lock into place. (Fig. 3)

Note: NEVER use stroller if wheels do not lock into place. If you need assistance, please contact our customer service department at 1-800-328-7363,M-F, between 8am and 4:30pm, PST.

CHILD TRAY

To attach the child tray:

Push the tray downward and onto each side of theFig. 5 front armrests until both side snaps into place.

(Fig. 6) Check that tray is securely latched in place. Repeat the above step for the rear child tray.

WARNING: The child’s tray is not a restraint device: always secure your child with the seat belt. DO NOT lift the stroller by the child’s tray. Use

care when attaching the child’s tray onFig. 6 the stroller with a child in the stroller.

To access the child seat:	release lever
To access the child seat:
Pull one side of the release lever (Fig. 7) located
on the underside of the child tray and lift upward.
Either side of the child tray will lift and rotate out
of the way to allow access to the front and rear	Fig. 7
seats. (Fig. 8)
To rotate the child tray:
In order to attach an infant car seat to the stroller,	Fig. 8

ASSEMBLY